Optronics Trailer Lights - Tail Lights - STL22RB Review Video

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is…

We offer high-efficiency LED-type trailer lights in various sizes, colors and shapes. The linked page will let you sort the results by clicking on the attributes you prefer. The results shown are already filtered to show only surface-mount red…

We have the Optronics Incandescent #MC65RB and Optronics Thinline LED #MCL75RB that use a red lens. The Optronics Incandescent #MC65AB and Optronics ThinLine LED #MCL75AB have an amber lens. A Optronics ThinLine LED #UCL65CB uses a clear lens with…

Those part numbers are for trailer clearance lights, and the main difference between 1a-v-1240R and 1a-v-1260r is that the 1240R is a led light, and the 1260r is a incandescent light. Both lights have red lenses and are 3 7/8 inches long, by 1 1/4…

To order trailer lights you will want to order by part number on your lights or by the size of the light you will need. The SAE stands for the Society of Automotive Engineers and the 97 DOT stands for the Department Of Transportation. These part…

Thanks for the photo of your trailer! Based on the photo you sent in, it looks like the Bargman LED Trailer Tail Light #47-06-404 that you referenced will work well for you. This light measures 6-1/2 inches long x 2-1/4 inches tall and is designed to…

The oil for the etrailer 4,500-Watt Portable RV Generator #333-0005 should be replaced after the first 25 hours of running time, and after that every 100 hours of operation or annually (whichever comes first). The recommended oil type is 10W-30…

That's a good question; the 4,500-Watt Portable RV Generator #333-0005 would not be able to run if the oil drops below a preset level, as indicated in the cut out of the linked installation instructions. There is an oil switch which will actually…

I went out into our warehouse and measured one of our Rubber Grommet for 6-1/2 inch Oval Trailer Light, #A70GB, that we have in stock. From the measurements I took, you will have to cut a hole that is 6-11/16 inches long and 2-5/8 inches tall.

From all the photos I saw online, it looks like Floe used grommet mounted 2-1/2 inch marker lights and standard 6-1/2 by 2-1/2 inch oblong taillights. If that's the case, for the amber 2-1/2 inch I would recommend #MCL59AB and #MCL59RB for the…

I am a little confused as to were the connector is, on the truck or on the trailer. Brown wires are typically associated with running lights. If there are 2 wires coming out of that pin and we are talking about the trailer side then you have what is…

It sounds like your problem may be limited to just one circuit - the wire that carries the right turn signal and brake light. To begin testing, I recommend checking the vehicle side and trailer side connectors for any signs of corrosion or damage and…