Optronics Light Guide LED Oval Trailer Light Installation Video

The lens of the #RVPL7CB pops out so that you can then replace the bulb with a new 1141 like the LED #DI75VR which will work well and last a long time.

34 inch frame hitch fits are for the cab and chassis model trucks. The part #C15312 does not fit cab and chassis model trucks so it would not be a fit for a 34 inch frame. The part #C15800 is an example of a Curt hitch that does fit a 34 inch wide…

To flat tow the vehicle you would first check the owners manual to make sure your model can be flat towed and to check on any special requirements. You would have to have base plates, a tow bar, safety cables, a lighting solution, and supplemental…

The part #277-000114 that you referenced can only turn on both lights or turn off both lights. They can not be activated independently. You may instead be interested in the LED Dome Light part #277-000340.

The Optronics LED RV Exterior Scene Light - Submersible part #UCL41CB is a surface mount light that installs using the two mounting holes in the flanges on either side of the light. The distance between the mounting holes is 7.87" and the…

Given the dimensions you provided, I believe that a u-bolt kit such as #CE23103 that's typically used to mount a 2 inch square trailer axle to the leaf spring pack would be your best bet. The kit includes two assemblies, each of which includes…

The U-bolts we offer with designed to fit a 2-1/8 inch frame are part #CE15501A. We do not offer any other U-bolts designed to fit a frame that size. I pulled one of the part #CE15501A U-bolts from our warehouse and took some measurements for you. I…

The 4 pole wiring harnesses we offer for trailers are pretty consistent when it comes to the wire gauge. The right turn/brake, left turn/brake and running lamp circuit wires are typically 18 gauge and the ground wire is typically 16 gauge. This is…

Yes, I am happy to say that we do carry clearance lights/identification lights that do not have the brake light function. That part is the Mini LED Identification Light Kit for Trailers - Submersible - Amber LEDs - Clear Lens #OPT89FR. These lights…

In regards to the Mini LED Identification Light Kit for Trailers part #OPT29FR, you will need to remove the grommet from the light and then push the light through the hole. Then, you can reinstall the grommet securing the light inside the hole.

Because the GloLight LED Backup Light for Truck or Trailer part #BUL111CB slightly diffuses the light around the outside of the light I recommend using the LED Backup Light for Truck or Trailer part #BUL10CB. This will give you a slightly brighter…

You can use this light #BUL111CB just as you are wanting to. You will just need to connect to the ground and the taillight function. This will just allow the ring to light up. The other connection will be the brake/turn connection which will light up…