Draw-Tite Class III, IV and V Pin and Clip Review Video

Using a Reducer Sleeve #e28JR is not going to reduce your trucks towing capacity unless you are using a lower capacity hitch. As you are most likely using a weight distribution hitch you should not have any issue with towing your 10,000LB travel…

The SumoSprings Trailer Helper Springs w/ Line Relocation Bracket #TSS-107-40 will work with 4,400 lb axles. It will fit your trailer so long as the axle is an overslung axle, which means the leaf spring will be over the axle. If you take a look at…

Since the etrailer Magnetic Hitch Receiver Reducer Sleeve #e28JR fits into a 2-1/2" receiver you need to make sure the pin you're using is able to reach all the way through. Some pins made for 2" receivers can still fit the…

Good question, and the hitch on your Audi is not rated for use with weight distribution, so what I recommend instead is a friction sway control set up. This will provide you with better control over your trailer to give you a much more controlled,…

The Draw Tite hitch part #DT73RR that you referenced weighs 37 lbs.

For installing a hitch on your 2022 Subaru Outback, most of the hitches we carry do require for you to remove your rear bumper during installation. If you are looking to avoid that step, I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver -…

For your 2018 Chevy Silverado 1500, you will need the BOLT Trailer Hitch Receiver Lock for 2" and 2-1/2" Hitches - Codes to GM Center Cut Key #BL7023582. The Hitch pin lock will work with the key styles pictured. The #BL7018446 you…

Yes, there is a 225/75R15 trailer tire that will fit a 15" x 5" trailer wheel, which is from Contender: - Load Range D: Provider ST225/75R15 Radial Trailer Tire #TTWTRTM2257515D - Load Range E: Provider ST225/75R15 Radial Trailer Tire…

The receiver tube on the Curt Class V hitch #C15302 does not have any reinforcement around the hitch pin hole. I went to our warehouse and checked this hitch to be sure. When this feature is included on a hitch it will usually be easy to see since it…

With Curt Trailer Hitch Receiver #C15302 installed on a 2003 Chevy Silverado 2500 short bed the hitch will be in the same position as a factory hitch or at least within a fraction of an inch. By that I mean the receiver will be right under the rear…

Curt Trailer Hitch Receiver #C15703 hangs pretty low on a 2005 Chevy Silverado 2500. From the bottom of the bumper to the top of the hitch receiver it is approximately 4 inches. I have included a picture showing the gap. A similar hitch, #C15302,…

If you check out the picture I attached you can see that the hitch opening for the Curt #C15302 that you referenced tucks right up under the rear bumpers so it would give you the exact same ground clearance as your current hitch. Which means your…