Customers compare 325-GH-096 to these similar products
Products Featured in this Video
What's up everybody. It's AJ with etrailer.com. Today, we're gonna checking out this Gen-Y pin and clip. It's gonna go with your Gen-Y ball mount setup like we have here. We got our one at the drop position. We got the ball mount accessory in here.… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
If you use the Curt hitch extender part #C45048 in the 24 inch length with a weight distribution system the towing capacity is 8,000 lbs. If the 24 inch length would work for you this would be a great option.
view full answer...Axles with low weight capacities like your 1,400 lb axle typically have a BT8 spindle so you'll need this kit: - Bearing Kit for 1" BT8 Spindle #BK1-100 This kit comes with L44643 Inner/Outer Bearings and a 34823 Seal with 1.249 inner and…
view full answer...While the Curt Fusion Ball Mount #C45134 is made in China we do have their similar Curt Solid Ball Mount #C45312 that is made in the USA. You will need the 2" Hitch Ball #CB26C and Gen-Y Hitch Pin and Clip #325-GH-096 to have all the parts made…
view full answer...Yes, you could use the Replacement Shank for Gen-Y Adjustable Ball Mount #325-GH-503 with a flat towing setup like you mentioned and it would give you right at the amount of drop you are looking for.
view full answer...Using a Reducer Sleeve #e28JR is not going to reduce your trucks towing capacity unless you are using a lower capacity hitch. As you are most likely using a weight distribution hitch you should not have any issue with towing your 10,000LB travel…
view full answer...The Curt Rebellion XD Shock Absorbing Adjustable Ball Mount w/ 2" and 2-5/16" Balls #C83WR is 8" from the bottom of the receiver shank to the bottom of the adjustable mount.
view full answer...The Curt Rebellion XC cushioned ball mount part #C83WR would cushion the ride quality and reduce the movement you are experiencing but an easier and most cost effective solution would be an anti-rattle device like the etrailer #e99007 which will lock…
view full answer...For the 2016 Thor Ace built on a Ford F-53 chassis the correct Roadmaster Reflex stabilizer is the part #RM-RBK22-RSSA. This will greatly help with sway from passing semi-trucks.
view full answer...Since the etrailer Magnetic Hitch Receiver Reducer Sleeve #e28JR fits into a 2-1/2" receiver you need to make sure the pin you're using is able to reach all the way through. Some pins made for 2" receivers can still fit the larger…
view full answer...No, the etrailer Magnetic Hitch Receiver Reducer Sleeve #e28JR will not lower the weight rating of your trailer hitch.
view full answer...Thank you for the purchase of the Draw-Tite #75229 trailer hitch and T-One #118275 for your 2015 Land Rover Range Rover Sport! We have exactly what you need to mount the 7-Way connector without having to modify anything. If you use the Easy Mount…
view full answer...The Replacement Shank for Gen-Y Adjustable Ball Mount part #325-GH-304 is my recommendation on an adjustable receiver used for flat-towing. It will provide up to a 7-1/2" rise or drop depending on configuration.
view full answer...