Stromberg Carlson Camper Jack - A-Frame Jack - JET-2500 Review Video

The description is talking about the 2 different tubes on the jack. The static outer tube has a 2 inch outer diameter. The inner tube that actually moves has an outer diameter of 1-3/4 inches. A foot with a 2 inch INNER diameter would fit around the…

I have provided a picture that shows the jack dimensions. These measurements were taken here by another Expert recently. The outer tube is 2 inches in diameter and the inner tube is 1-3/4 inches in diameter. The bracket to mount the jack uses a…

The Bulldog Powered-Drive Trailer Jack #BD500187 has an outer tube diameter of 2-1/4 inches and an inner tube diameter of 2-1/16 inches. This jack should be able to work on your trailer but it really depends on the diameter of the hole in your…

What you need to look for will be power and the amount of lift. With your trailer weighing 7,621 pounds, you are looking at a tongue weight of 762 pounds to 1,100 pounds. With that being said, the Stromberg Carlson Electric A-Frame Tongue Jack…

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack that…

Hey Chris, it sounds like all you'd need to connect the MB Sturgis Propane Extension Hose for Small Appliance #100284-144-MBS to the Camco Automatic Changeover 2-Stage Propane Regulator for Dual Propane Tanks #CAM59005 is the MB Sturgis…

The JET-2500 Electric Trailer Jack you mentioned does indeed have mounting holes that are the industry standard 3 inches apart on center.

I looked through all of our available manual A-Frame trailer jacks and the option with the shortest retracted bracket height is the etrailer.com A-Frame #TJA-2001-B. The retracted bracket height is right at 5-1/8 inches from the ground and it has a…

It sounds like you may need an electric jack with a 2-1/4" outer tube diameter and 2" inner tube diameter such as Electric Jack #EJ-3520-BBX. This jack has a 3,500 lb lift capacity, with a 9" retracted height and 28-1/2" extended…

Your best option is going to be to take your trailer to a welder/fabricator and explain to them that you need to have either that lower plate removed or expanded so that you can fit a new trailer jack in it's place. The standard jack outer tube…

I recommend using the Electric Jack w/ Footplate #EJ-3527-BBX that you were looking at because it will easily handle the 7000-lb GVWR of your Winnebago Minnie 2201DS. This jack does not require any wiring since it will plug into your vehicle's 7…

The manual emergency crank for the etrailer.com Electric Jack #EJ-3527-BBX (which is included) requires a 3/8" socket for operation. I have attached a short video review on this jack that you can check out as well.