Erickson Trailer Axle Strap with D-Rings Review Video

Powder coating and galvanization are both about the same in terms of rust resistance. If you like the black of the part #e42VR it would work just as well as a galvanized version #e62VR.

The Bulldog #BDW20351 and #BDW20230 do use the same ratchet straps and carry bag, the #BDW20351 does have more accessories. It includes 4 flat-ring axle straps, 4 padded covers, and 4 cinch straps, whereas the #BDW20230 does not.

You are correct. The #BDW20351 comes with 4 padded axle strap covers for paint protection while the #BWD20350 does not. Otherwise these strap kits are identical. Since you are planning to use this 2019 Corvette Grand Sport I would definitely choose…

It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…

For your Dodge Challenger I recommend using the Erickson E-Track Tie-Down Kit #EM58523-09162-4. With this kit you get 4 e-track wheel straps that will provide you a great way of securing your Challenger. The straps will be easier to route around the…

If you installed e-track on the floor of your trailer like the part #EM19147 you could use the Erickson E-Track Tie Down kit part #EM58523-09162 which would attach to the track and since it has a strap length of 12 feet it would easily fit a 35 inch…

You could get by with 4 foot sections of e-track like the #EM19147 with the wheel chock setup part #EM58523-09162-4.

You can install the Erickson Horizontal E-Track #E19148 in any manner you like, so for a car hauler that has cars of different widths you can place E-track side-by-side, as you can see one of our customers did in the accompanying photo. This E-track…

I'd recommend through bolting the e-track into the available cross members under the trailer floor. You'll want to fasten the e-track to the floor in between those points, but the fasteners you'd use and how many of them will depend on…

If you are planning on using an E-track wheel strap like the part #EM58523 (which would be your best and easiest option for securing the vehicle), you would want to space the E-track sections the exact same width as the tires on your vehicle. Right…

On an 4 foot long section of E-track #EM19147 and 2 screws every 16 inches that is a total of 6 screws in the aluminum frame. This most likely will not get you near the capacity of the E-track. I recommend bolting through the aluminum frame so that…

I think we have just what you are looking for. Check out our Stake Pocket Tie-Down Anchor, #WFSPDR. This anchor mounts in the stake pockets on your trailer and gives you a d-ring tie-down point. These will work great with the Bulldog Winch Tie-Down…