Demco Trailer Connector Adapter Review Video

You could install a diode wiring kit in the F-150, but the quickest and easiest route here would be to simply plug in some tow lights like the Roadmaster Standard Magnetic Tow Lights #RM-2120. If you are set on wanting to run the signals through the…

I recommend using the Roadmaster 7-Wire to 6-Wire Flexo-Coil Kit #RM-146-7, simply cut off your current 4-Way and rewire with the 6-Way to provide the charge line for your towed using the Battery Charge Line Kit #RM-156-25. The Kit allows up to 15…

I would be happy to recommend everything you need to flat tow your 2021 Ford F-150. I recommend the Blue Ox Base Plate Kit #BLU33FR which is confirmed to fit your vehicle and will pair up perfectly with the Blue Ox Avail Tow Bar #BX7420. Since the…

To see a couple diagrams that show how the 6-way to 7-way adapter part #47435 is wired up check out the pictures I attached. The 6-way of this adapter has the center pin as the 12 volt circuit. That is the usual circuit that gets moved around on…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

What you need is a light kit specifically for flat-towing. The Plug-N-Tow TM Vehicle Wiring Harness, #42615, would be if the Jeep were towing a trailer and not for activating its lights while it is being towed. There are a few options for lighting…

The Roadmaster part #RM-146-7 would be longer than the Demco part #DM9523054 that you referenced. The Roadmaster is listed as having an extended length of up to 8 feet whereas the Demco is 7 feet so at 7 feet the Roadmaster would have less tension.

I have attached for you below a diagram of how to wire the vehicle side plug on the Roadmaster 7-Wire to 6-Wire Flexo-Coil Kit part #RM-146-7. That said, you must know the function of each wire which can be found with a circuit tester, you cannot…

The Demco 7-Wire to 6-Wire Coiled Electrical Cord #DM9523054 you found is used to connect a tow vehicle to a vehicle being flat towed. It is not designed for a trailer with hydraulic surge brakes. If you can tell me what surge brake actuator you have…

We do have similar 7-Way to 6-Way connectors that do not glow. You could use #HM47083 if you need 12 volt power on the center pin (on the 6-Way end). Or you could use #HM47085 if you need the center pin to pin for electric brake output. These items…

There isn't a way to access the wiring within the connectors on the Hopkins Nite-Glow Tow Bar Extension Cord #HM47054 without cutting it open. But you can access the wiring and change the positions on the Blue Ox version #BX88206 or Roadmaster…

Sounds like your dinghy vehicle is getting corrosion in it's tow bar lighting connector from driving the vehicle in inclement weather. If you wanted to go with the kit part #HM47044 that would be a great solution to give you a new umbilical from…