Curt Front Mount Trailer Hitch Skid Shield Review Video

The only front mount trailer hitch receiver that we offer at this time for a 2014 GMC Yukon and Yukon XL is the Curt Front Mount Hitch #C31012. This is a 2 inch hitch that offers a 9,000 lbs Line Pull capacity and a 500 lbs Vertical Load capacity.…

For your 2020 Ford F-150 XLT the best front mount hitch is the Curt #C31083 because it's going to sit just a tad higher than the Draw-Tite alternative for better ground clearance. The 2" receiver for the Curt hitch will actually…

I am not sure why the instructions are not opening for you so I can email them to you in a separate email. But in the instructions step 4 says to drill four 17/32 inch holes. There is some fascia trimming required to install the hitch also shown in…

The good news is that neither the Curt #C31083 or the Draw-Tite #65067 front mount trailer hitches will reduce the ground clearance on your 2018 Ford F-150. If you want a receiver that sits above the lowest piece of fascia then the Curt requires that…

The Draw-Tite Front Mount Trailer Hitch Receiver #65067 and the Curt Front Mount Trailer Hitch Receiver #C31083 are both confirmed to fit your 2020 Ford F-150. They are very similar in design and mount to the same locations on the frame, however the…

I don't have an exact figure I can give you, but what you can do is check out the picture I attached that shows where this hitch will locate relative to the front end of your truck. You will need to find that same area on your truck and then…

The Curt Front Mount Trailer Hitch Receiver part #C31083 will require a slight trimming of the lower plastic bumper fascia but there will be no drilling or alterations that will be needed on the vehicle's frame. The trimming of the lower plastic…

The Draw-Tite Front Mount hitch part #65067 installs so that it sticks out from the plastic air dam of the Ford. The hitch does not sit lower than the lowest part of the truck so it does not reduce ground clearance. I have attached a photo for your…

The dimensions of the Replacement Upright for CE Smith Bunk-Style Guide-Ons #CE27605PG are 39 inches tall by 23 inches long. The tube is 1-1/2 inches and the bend is a 90 degree angle. I've attached a picture for you as well.

On your 2020 Ford F-150 the Curt Front Mount Trailer Hitch #C31083 will sit further up than the Draw-Tite alternative and actually won't affect the truck's ground clearance at all. The 2" receiver on the hitch will protrude right through…

The only front mount trailer hitch options for a 2017 Ford F-150 are the ones that mount below the bumper such as the Curt Front Mount Trailer Hitch Receiver part #C31083 which is what I recommend and will fit EcoBoost models. The EcoHitch Hidden…

The Curt Front Mount Hitch #C31083 for your 2020 Ford F-150 actually won't affect the truck's ground clearance at all. This is because the 2" receiver will protrude right through the bottom of the air dam, maintaining the F-150's…