Front Mount Trailer Hitch Installation - 2008 GMC Yukon - Curt Video

The only front mount trailer hitch receiver that we offer at this time for a 2014 GMC Yukon and Yukon XL is the Curt Front Mount Hitch #C31012. This is a 2 inch hitch that offers a 9,000 lbs Line Pull capacity and a 500 lbs Vertical Load capacity. To…

I spoke with my contact at Curt and he told me that there is only one mounting option for the Curt Front Hitch, #C31012. This hitch was designed to mount to the underside of the frame rails, hanging below the frame as it is pictured (see photo). He…

I am not sure why the instructions are not opening for you so I can email them to you in a separate email. But in the instructions step 4 says to drill four 17/32 inch holes. There is some fascia trimming required to install the hitch also shown in…

The Draw-Tite Front Mount Trailer Hitch Receiver #65052 is not a confirmed fit for your 2010 Chevy Suburban Z71. The Z71 is excluded from their fit, so I recommend the Curt #C31012 instead. It will required drilling and some trimming of the front air…

I contacted our representative at CURT about the CURT Front Mount Trailer Hitch #31322. He informed me that the distance from the center of the hitch pin hole, to the front edge of the bumper measures approximately 7 inches. We do not have a Hidden…

I can help you with greasing up your EZ Lube Axle. First thing I would check would be that the grease is not coming out of the back of the axle through the seal. If this is the case you will need to replace the seal. Our tubes like #L11390 have 14…

Standard tapered trailer wheel bearings are recommended to be re-packed with fresh bearing grease about every year or every 12,000 miles under normal use. In certain conditions this interval could be shorter, such as if you routinely tow the trailer…

The biggest difference between the Curt front hitch part #31198 and Draw-tite front hitch part #65080 is that the Draw-tite receiver tube extends out more than the Curt by over an inch. This makes it more visible when nothing is mounted to it.…

There are not installation instructions available specific to the Replacement MaxxAir Roof Vent Manual Lift. I have attached an exploded diagram that shows the placement of the lift in the fan assembly for your reference.

The Draw Tite hitch part #65052 is a confirmed fit for your 2007 Chevy Tahoe and will bolt right up to the frame without any modification. It does drop down 7-3/4 inches from the frame where it attaches as well like you mentioned.

Although both the Curt #C77NR and #C37BR both look to be identical there is a small difference in the #C77NR that allows it to be compatible with 2022 and 2023 Kia Niro models, whereas the #C37BR is only compatible with 2022 models.

I reached out to a representative of Draw-Tite who explained that the front mount trailer hitch #65052 that fits your 2014 Chevy Suburban LTZ will require trimming "up to the bottom of the bumper fascia" and sent the accompanying photo…