What Size Holes Need to be Drilled to Install Curt Front Mount Hitch on a 2014 Chevy Silverado
Question:
I cannot open the installation page! What size holes have to be drilled? My 2014 Silverado High Country has the crash avoidance system and parking assist system intergrated into the front bumper. With this installation, combined with the license plate holder interfere with these installation?
asked by: Jack S
Expert Reply:
I am not sure why the instructions are not opening for you so I can email them to you in a separate email. But in the instructions step 4 says to drill four 17/32 inch holes.
There is some fascia trimming required to install the hitch also shown in the instructions so you will need to compare them to your truck to see if the crash avoidance system or parking assist system will get in the way. Based on pictures I have seen of the hitch installed on customers trucks I do not believe it will be a problem.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Front Mount Hitch
- Q&A: Recommended Front Mount Trailer Hitch for a 2014 GMC Yukon and Yukon XL
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Video: Front Mount Trailer Hitch Installation - 2008 GMC Yukon - Curt
- Video: Curt Front Mount Trailer Hitch Skid Shield Review
- Video: Dutton-Lainson Trailer Jack - A-Frame Jack - DL22530 Review
- Video: Durabilt 1/2 Inch Safety Chain Connectors Review - 2018 Ford F-250 Super Duty
- Video: Durabilt Hammerlock Coupling Link Review
- Video: etrailer Rubber 2" Hitch Cover Review
- Shop: Curt Front Mount Trailer Hitch Skid Shield
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Front Mount Hitch Receiver Location on a 2007 Chevrolet Tahoe LT3 Z71
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Snow Plows
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Search Results: step bumper
- Q&A: Comparing Curt Front Mount Hitches For 2016 GMC Sierra 4-Wheel Drive
- Search Results: front trailer hitch
- Video: etrailer Hitch Covers - Misc Covers - 22282 Review
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Detail K2 Summit II Elite Snowplow - Custom Mount - Electric Actuator - 88" x 26"
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Q&A: Recommended Replacement A-Frame Trailer Jack for 2003 Viking Legend Trailer
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Q&A: A-Frame Trailer Jack Recommendation with Outer Tube Diameter of 2 inches
- Q&A: Replacement A-Frame Jack For Atwood Mobile Product Jack On Trailer With 2" Diameter Mounting Hole