Roadmaster Exact Center Steering Stabilizer Installation - 2005 Workhorse W-Series Video

Yes I can! For a front sway bar to fit your 2005 Fleetwood Bounder 34F built on a Workhorse W22 chassis you would want the Roadmaster Front Sway Bar part #RM-1259-105 and for a rear sway bar you would want the part #RM-1259-108. I confirmed these…

When installing the Roadmaster Front Anti-Sway Bar and TruTrac Rod Kit #RM-1259-106 you will want those brackets sit flush; you can enlarge the hole or drill a new one so that you can get the bracket sitting flush to the rail. My contact over at…

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

The Roadmaster Rear Anti-Sway Bar for Motorhomes #RM-1139-143 can use your factory u-bolts if they are long enough. If they are not, then Roadmaster recommends using the 7/8 inch diameter u-bolts that are longer (most likely the larger diameter due…

For your 2008 Workhorse W22 Chassis, I recommend the Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class A Motor Homes #RM-RBK13-RSSA. This system has a tempered steel spring that works when compressed to push back to center and…

In regards to the Roadmaster Reflex Steering Stabilizer part #RM-RBK13-RSSA, the chassis bracket which is the larger of the two will be installed on the passenger side preferably but can be installed on the driver side as well. That said, I don't…

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

The Roadmaster TruTrac Front-Axle Trac Rod for Large Trucks and RVs #RM-TRACW-22 is manufactured in-house at Roadmaster's Vancouver, Washington facility. We list it as being made in the USA and I called Roadmaster as well and confirmed it, so you…

The front trac bar that comes in the Roadmaster Kit #RM-1259-106 that you referenced will do the same job as a steering stabilizer but won't be as effective. For the best of both worlds I recommend going with the front Anti-Sway Bar #RM-1259-105…

I have a solution for you, but the #ACM150 is not a direct replacement for your current Coleman Mach unit. Instead, the Advent Air RV Air Conditioner - 15,000 Btu - White #ACCOL150 is a direct replacement for your Coleman Mach 8000 unit and comes…

The best option we have to replace the Coleman Mach Ducted 13,500 Btu RV Air Conditioners is the Advent Air Replacement RV Air Conditioner for Coleman Setup part #ACCOL135. These will be direct replacements which will reuse all the existing wiring,…

The correct replacement overhead unit for an Airxcel 8000 Series Air Conditioner which is made by Coleman Mach is the Advent Air Replacement RV Air Conditioner for Coleman Setup w/ Start Capacitor part #ACCOL150. There won't be any issues reusing…