Pollak 7-Pole Trailer Connector Socket Installation - 2000 Ford Expedition Video

The closest thing we have is the installation of the #RM-8700 on a 2014 Wrangler which I attached below. Although it isn't exactly the same you can use it as a general reference coupled with the written instructions.

If you check out the video I attached you can see how 7-way harnesses like the one you referenced disconnect at the rear of them. Right at the 46 second mark you will see the pin that has to get removed.

If you are asking which pin you will wire the 12V power source to on wiring like the Blue Ox 6-Wire, Coiled Electrical Cord with 6-Way, Round Plugs #BX8862 then yes, the 12V power will be wired to the center pin. The 12V power pin can be used to…

My contact at Blue Ox was able to confirm that in their Coiled Electrical Cord with 6-Way Round Plugs #BX8862 the wires gauges do vary. The ground wire is 12-gauge but all other circuit wiring is 16-gauge.

It appears you are connecting your tow vehicle wiring to a 6-way connection like the RoadMaster 6-Wire Flexo-Coil Kit #RM-146. Making these connections is not difficult and I've attached a video and photo as well as linked an article to…

My contact at Torklift confirmed with me that you can use any 1/4 inch snapper pin to replace the one that was included in the hardware kit. The Curt Coupler Safety Pin, #K-8P, is a 1/4 inch pin that has a usable length of 2-3/16 inches. If you…

First, make sure that your #3015-P harness is pinned out correctly. The red wire should be in the bottom left location (if looking at the back of the end that plugs into the truck). Directly next to the red wire should be the blue wire. Above the…

You can still use the connector you have but you would need to move the red wire of the connector that plugs in to the vehicle to the opposite corner of the connector. Once you do that the brake controller will work just fine. I attached a picture…

The distance from the center of the hitch pin hole of etrailer.com Trailer Hitch Receiver #E98854 to the edge of the rear fascia (or the edge of the rear bumper) on your '10 Town and Country is approximately 4 inches. For wiring which will…

The receiver with the best clearance is the Curt Trailer Hitch Receiver #13364 which has a hitch pin hole to rear bumper length of 4". The height to the top of the receiver tube is 12-1/4" The etrailer Trailer Hitch Receiver #e98854…

The etrailer brand #e98854 Class III hitch would install using hardware that is already existing on the vehicle, so no separate hardware is needed. You can see this by consulting the linked installation instructions or taking a look at the linked…

The etrailer.com hitch part #E98854 is a confirmed fit 2 inch hitch with plenty of capacity that is confirmed as a fit for your 2018 Dodge Grand Caravan. I recommend this hitch highly as it has great towing capacities at 4,000 lb trailer weight and…