Optronics RV Combination Drivers Side Tail Light Installation Video

I went out to the warehouse and used our wire gauge measuring tool to measure the wiring on Low Profile RV Combination Tail Light #RVSTL61. It falls between 16 and 18 gauge wire so at the tightly wound ends it would measure a little smaller. So in…

The best trailer tire solution for a 12 inch wheel will be the Taskmaster 5.30R12 Radial Trailer Tire #TT53012C for a couple big reasons. One being that the tire is a radial which is much preferred to the bias ply style of tire you referenced. They…

The Ceiling Vent Assembly with Built In Thermostat for Advent Air RV Air Conditioners - Non-Ducted #ACDB measures 22-1/2" long x 21" wide x 2-1/2" tall when assembled.

There are two air distribution boxes for the Advent Air conditioners that we offer. Both have thermostats however, one is a wall mounted and the other is built in. I recommend the Air Distribution Box Item #ACDB which has a built in thermostat and…

Since you want to switch to LED lights, I recommend the #328-003-81LM1 and #328-003-81M1 from command electronics. The driver side light is 8-11/16" long x 5-7/8" tall x 2" deep including the license plate mounting bracket,and the…

The part #RVSTL61 is an individual driver side light, if you wanted the passenger side to go with it you'd want the part #RVSTL60. I am confident these lights could be used on your trailer, but they won't be an exact replacement for what you…

Yes, the Dexstar Vintage Steel Wheel #AM20395 should work well for you. This is a 15 inch rim with a 4 on 9.44 inch bolt pattern like what you have.

We do indeed carry Optronics products. The number you provided is a DOT reference number, and does not denote the part number of the lamp or the lens. However we had a picture sent in once from a guy of the housing of the light he needed a lens for…

The easiest way to test the functions of the taillight wiring on a trailer is to use a jumper wire. You will touch one end of the jumper wire to the positive post of a 12 volt vehicle battery and then touch the other end of the wire to all of the…

Thanks for the picture! I reached out to my contact at Optronics and the lights in your pictures have been discontinued. The closest replacement option currently available is the Low Profile RV Combination Tail Light - Stop, Tail, Turn - 9 Diodes -…

Those are going to be a taillight adapter that was most likely produced solely by Shasta for your camper. It's primary purpose is to give the taillights a better mounting surface and place to conceal the wiring. It is similar to the Wedge…

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.