Hopkins Backup Sensor System Installation - 2006 Chrysler Town and Country Video

The Hopkins License Bracket Mount Backup Sensor System #HM60100VA is a universal-fit item intended to fit a wide range of vehicles. Its fit is not specific to one type or style of vehicle. It mounts using the standard hole spacing for your license…

The Hopkins Backup Sensor system #HM60100VA should fit as it is designed to fit standard mirror plate dimensions, but to be sure you can compare the measurements of this with the current license plate frame you have to see if it would be too big.…

I attached two pictures that are the install instructions for the Hopkins BackUp Camera part #HM60100VA that you referenced as well as a link to an install video down below for you to check out.

The Hopkins Backup Sensor System - Audible Alert - License Bracket Mount part #HM60100VA is designed to be mounted on the rear of the vehicle. It can be physically mounted to the front of your 2007 Chevrolet Suburban, however, the installation…

The Hopkins Backup Sensor System - Audible Alert - License Bracket Mount, #HM60100VA, is designed to be wired in with the reverse light circuits so it will only be operating when in reverse and not while towing or parked. If you are still concerned…

The distance of 5-1/2 feet is measured from the sensors on the Hopkins #HM60100VA. If installing this on your 2020 Silverado means you have a few inches between where the sensors are located and the edge of your bumper then you would need to account…

Yes, the Hopkins Backup Sensor System item #HM60100VA, can be mounted upside down. However, if your rear bumper protrudes out below the license plate, then the backup sensor will not be able to pickup items that are low to the ground. The sensor…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.