Bright Way Trailer Breakaway ICU Kit Installation Video

The alarm on the Bright Way #BW94FR is designed to go off whenever the trailer is disconnected. So as soon as it no longer senses power from the 7 way plug on your truck, it will activate the alarm. It sounds like the 7 way plug on your truck only…

The lid of the Bright Way Trailer Breakaway ICU Kit with 12V, 5-Amp-Hour Battery, Charger, and Wire Loom #BW94FR that you referenced has a wiring diagram shown that details how it wires. Not seen is there is a single wire that runs up to running…

The Bright Way Breakaway Kit #3802346 cannot be charged through a 12V circuit because that would result in overcharging the battery which is why it has its own battery.

Wiring in the parking light diode #RM-690 is easy. All you have to do is locate the wire leading to the parking light bulb. Cut the wire and insert the diode in-line with the wiring. The IN side will be the part of the wire that leads to the front…

You can isolate the break away battery from the auxiliary battery using the Battery Isolation Solenoid #PK5231201. The auxiliary power supply that is needed on this solenoid can be the running lights of your trailer. That way, when your trailer is…

Typically people will let the breakaway battery run the breakaway system and then would use the accessory battery to power the interior lights etc. This tends to work the best since your breakaway battery needs to always be charged and interior…

The harness you have pictured is the Toyota factory brake controller harness. Toyota usually issues these with each truck. This will work with the Prodigy P3 Brake Controller, #90195, that you purchased. The P3 should have come with a universal…

It's very common for smaller single axle trailers to have brakes installed on them already. Most likely if you look you'll find options in the size you want that are already set up with brakes. This would be the easiest and most…

Yes, you can bolt the Bright Way Push-to-Test ICU Trailer Breakaway Kit item #BW94FR to a flat surface to install it. I have attached an installation video to walk you through the process.

The 10-36 seal that is included in the #BK3-100 kit will work great on your trailer. This kit comes with the inner bearing and race, outer bearing and race, grease seal and a cotter pin.

First thing to check is the grounds of the trailer lights. Insufficient trailer taillight grounds are notorious for causing seemingly unexplainable taillight behavior like what you described. Make sure that the trailer side connector are clean and…

It sounds like you're looking for the Roadmaster Split Bushing for Anti-Sway Bar part #RM205222-10 and Replacement U-Clamp Bracket for Roadmaster Front Sway Bar part #RM-B141. Please note, you will need to use a marine type grease between…