Review of etrailer Trailer Jack - Side Frame Mount Jack - TJDDP-20000SP-F Video

Send me the pictures you have and I'll see if it's something we can get.

Since you are limiting your trailer to 10000lbs, and the average tongue weight is 10-15% of the trailer weight, you are looking at 1000-1500lbs tongue weight. With that said it is a good idea to use a jack with a larger capacity as it will be able…

I spoke with my contact at Fulton jacks and he stated that what you are describing is a symptom of the jack screw inside the jack seizing up. Jack companies don't make the internals of their jacks easily accessible for cleaning and…

The threaded rod you are looking to replace is not a universal fit for all jacks. I recommend taking a look at the components in your jack to determine the correct replacement. There are a few options we carry but the Bulldog winches have a very…

I am not aware of any way to convert a single speed jack to a two speed jack. Therefore, you will need to replace the single speed jack with a two speed if you want this operation, the Square 2-Speed Jack with Crank part #TJD2SP-12000SP-F for…

The Ram 14K jacks don't have a replacement rod and nut available like the 12K #TJD-12000-RODNUT and are no longer available in that capacity. I recommend changing out your jacks for the 12K option. You can use the Bulldog Side Wind Jack…

We have the Buyers Products Heavy-Duty 4" Square Jack w/Front Pin Drop Leg #3370091415H that matches the design of the jacks on your gooseneck trailer. We will only have the jack assemblies and will not have the crossover tube or handle…

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. So your 14,000 pound trailer would have a tongue weight between 1400 lbs and 2100 lbs so any trailer jack rated over 2,500 lbs would be sufficient to lift the…

I called my contact at Bulldog about the Replacement Planetary Gearbox Kit, part #BD500330. They told me you can install this on your single-speed Bulldog jack. They said you would remove the old gearbox and replace it with the #BD500330, and may…

Yes, in order to use the Square 2-Speed Jack w/ Crank part #TJD2SP-12000SP-F in tandem you would need to obtain the correct follow leg which is the Square Direct Weld Jack part #TJD-12000SP-F2. The handle for this follow leg can be discarded as you…

The Square Direct Weld Jack #TJDDP-20000SP-F will need to be welded on to the trailer frame by an experienced welder. So if you're using this to replace an old jack then you'll need to cut off the old jack and have this installed by…

For your Ram 10,000 lb jack, it sounds like you will need to rebuild it as the amount of force used most likely damaged the gears and the threaded rod. I recommend the Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K…