Review of etrailer Tie Down Anchors - E Track Backing Plate 3 Pack - e46RR Video

While we do have a variety of winch mounting options, I can't say for certain that any of them are a specific replacement for your Aluma Series 82 car trailer. With that being said, we do have a universal winch mounting plate as part #BDW20291…

That is a good question, and you will need to use three backing plates for each 5 foot section of e-track, so the exact part you will need is the following: - etrailer E-Track Backing Plates w/ Hardware - Qty 3 #e46RR These will fit perfectly with…

To secure the Erickson Horizontal E-Track #EM59150 you need to use the E-Track Backing Plates #e66RR to secure them to the floor. The screws can easily pull out of the plywood especially considering your van will be absorbing a lot of road shock. You…

One nice thing about the #EM98CV is you can use a variety of mounting hardware to suit your needs depending on where and what you're mounting them to. You can certainly use lag bolts to mount the wheel chocks to your plywood floor, this won't…

I didn't receive your photos, but the manner in which you attach the e-track to your trailer deck will completely depend on what the deck is constructed of and where exactly on the deck you'll be placing the e-track. Without knowing any…

You should use the backing plates instead of U-bolts in order to install the etrailer Horizontal E-Track - Galvanized Steel - 2,000 lbs - 94" Long #e62VR. U-bolts won't allow for the most secure mounting of the E-track, so you really do want…

If you didn't want to drill down into the frame of your trailer you could use short wood screws to attach to just the plywood floor. I would recommend using a screw in every hole though for the #EM19147.

There are so many variables involved here, including the size of the bikes, how you want them to sit in the trailer, the weight of the bikes and the geometry of the bike's frames that I couldn't begin to provide you with specifics, but…

It looks like each chock and strap from 2 of #EM09160 will need to be able to hold around 375 pounds to handle the weight of the 2014 Arctic Cat Wildcat X Limited and that is just static load and does not include the forces applied to the chocks and…

The chock included with the #EM09160 Tie Down Kit is 5-3/16 inches wide, 8 inches long and 2-1/8 inches tall. The mounting holes are 4-1/2 inches across, measured center to center. The closer set of holes are 2 inches apart, with the distance from…

E-Track like #E19148 is zinc-coated steel and since the trailer is aluminum you would want to paint the bottom of the E-Track. Otherwise the dissimilar metals can cause corrosion to start. Be sure to also consider the fasteners used. Zinc-coated…

In order to wire your cargo trailer for both 12 volt DC and 110 volt AC power you would need to install a AC/DC distribution panel and power converter which we currently do not offer. You would then wire the 12 volt power to the converter along with…