Review of etrailer Gooseneck Trailer Coupler - Coupler with Outer and Inner Tube - GCPN-25008 Video

The weight capacity of the Ram Gooseneck Coupler part #GCPN-30008 is 30,000 lbs of gross trailer weight and 3,000 lbs of tongue weight.

I have a replacement axle option for you, but based on the information I was able to find on your AL-KO 4400lb Axle #402268 it uses an older style of braking assembly that was discontinued when AL-KO was bought out by Dexter. If the brakes on your…

The Bulldog BX1 gooseneck couplers have that handle assembly at the bottom so the lock that would fit at the bottom of the coupler in lock set #BLTL-53-40D2 would not fit. The BX1 series of gooseneck couplers can be locked with a padlock which you…

I do have a few easier options for you to determine the weight capacity of an axle other than using the bolt pattern or the number of lug nuts. The problem with using the bolt pattern to tell the axle capacity is that an axle may have the a bolt…

The Convert-A-Ball Multi-Cushioned Gooseneck Trailer Coupler #CG that you referenced is an inner tube portion of a gooseneck hitch. The outer tube would have the set screws that secure it in place. I attached a picture that shows it installed for…

There are many ways you can secure wires to a trailer. I would not recommend the use of tape as it will wear out quickly when exposed to the elements. Soldering is also not recommended because it is a more permanent method and you may need to…

When a trailer with electric brakes is connected to a vehicle that has a brake controller that brake controller is sensing the draw of the brake magnets by sending back a small amount of voltage on the blue wire. The brake controller also get's…

Your problem is in the wiring in one of two places. It is either on the vehicle wiring harness or somewhere in the wiring on the trailer. The first thing to do would be to narrow it down to one of these two places, then we can pin-point the problem…

Having a 1.25 spindle, it can be a few bearings that will fit. However, there will not be a hub that uses both an inner and outer bearing of this size. With that said, I highly recommend replacing your axles with something that will use a more common…

To replace a spindle, the old one would need to be cut off, and the new one welded into place. This is NOT a job for the do-it-yourselfer. The new spindle must be absolutely square with the axle in order to prevent premature tire wear and wheel…

The inner diameter of the tube of the Convert-A-Ball Multi-Cushioned Gooseneck Trailer Coupler #CG is 3-3/4 inches. This is designed to slide into existing 4 inch inner diameter tubes on trailers.

The Convert-A-Ball Multi-Cushioned Gooseneck Trailer Coupler #CG will work in your gooseneck hitch so long as your outer tube is round with a 4-inch inside diameter and it has bolts to secure this inner tube component. Most gooseneck trailer outer…