Tongue Weight Rating of 30K Round Ram Gooseneck Coupler

Question

Question:

what is the TW rating

asked by: Peter E

0

Expert Reply:

The weight capacity of the Ram Gooseneck Coupler part # GCPN-30008 is 30,000 lbs of gross trailer weight and 3,000 lbs of tongue weight.

expert reply by: Conner L

0

Answer 1

We do carry the hardware kit #3378530 which will fit the buyers Pintle hook #337PH45 that you were looking at. The bolts technically are made for the buyers 30 ton pintle hook like part #337PH30. They will fit the 45 ton just fine. These are the…

view full answer...

Answer 2

We sell a bolt kit for the #337PM25812 which comes with the correct size bolts and hardware as part #3378525 actually which includes bolts that are are 9/16 inch in diameter and 2-1/2 inches long.

view full answer...

Answer 3

Grade 8 bolts are recommended for installing the Buyers Products 3" I.D. Heavy-Duty Forged 4-Bolt Mount Lunette Ring #337BDB1394 that you referenced. We actually have a mounting kit for this with part #3378530 that includes the bolts. Then…

view full answer...

Answer 4

The Buyers Products 15 Ton Swivel Type Pintle Hook part #337BP125A can fit lunette rings with an inside diameter of 2-3/8" to 3". So either one would be fine as long as they are rated properly for the weight of your trailer.…

view full answer...

Answer 5

We have a few different adjustable gooseneck couplers available. We offer a Bulldog Gooseneck Coupler with a 20K capacity which adjusts from 29 to 35 inches, part #BD0287600300. The coupler is for a 2-5/16 inch ball and features a 4 inch inside…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Tongue Weight Rating of 30K Round Ram Gooseneck Coupler

Product Page this Question was Asked From

Continue Researching