etrailer Trailer Bearings Races Seals Caps - Seals - RG06-050 Review Video

After speaking with EZ Loader what you have on your trailer is a 3,700 lb axle. From what they said the axle was upgraded even though your overall trailer capacity is 3,100 lbs. Although this uses the same #L44649 outer and #L68149 inner bearings,…

I have included a diagram below with the measurements of the #K71-359-00 equalizer. The shackle links included with this kit are 2-1/4" long when measured center hole to center hole. The kit is intended for use with 1-3/4" wide double eye…

The Dexter bearing kit part number K71-717-00 that you referenced is the bearing kit for a number 84 spindle. Our part number for that bearing kit is #BK2-100.

I have tried to contact and have left many messages for EZ Loader to get the information on your bearings and seals. Unfortunately they haven't returned any call or email, so the best way to help you is to have you pull one of the hubs off your…

In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first thing you will need to know is the bolt pattern of your hubs. This is so you get a hub that is compatible with your…

Grease Seal #RG06-050 is the replacement part for the Dexter 010-019-00. It is 1.719 inches inner diameter and 2.565 inches outer diameter. It is a fit for 3500 lb axles. This is a confirmed replacement cross-reference.

The Hub Bearing Kit for Lippert, Dexter, and Al-Ko Axles - 3,500 lb with #84 Spindle #BK2-100 falls under the etrailer brand. This kit includes the common bearings and seal for a standard 3,500 lb axle.

Yes, the Bearing Kit #BK2-100 does come with the tang washer and everything you see in the picture I attached. I attached a review video that shows everything included as well.

The best way to find the bearing numbers of your trailer is to pull the hubs and read the numbers on the current ones or measure the spindles where the bearings sit. You may be able to find a tag or stamp on the axles and use it to find information…

Although there are standard bearing and seal combinations, sometimes (especially on older trailers) the "correct" seal won't fit, as you have found out. The closest seal that we have to the 1.654 Inner Diameter (ID) that you measured is…

Bearings are known to fit tight and sometimes require a bit of wiggling to get to install but you really should have to have them pressed on. Does the spindle need to be cleaned off? Was one of the bearings able to slide on easily but the other not…

Although the equalizers included with the Dexter #K71-359-00 Heavy Duty Suspension are a 1/2 inch taller and a 1/4 inch different in width than the original equalizers, that difference isn't enough to affect the fit. The trailer height will be…