Performance Tool Carbon Fiber Digital Caliper Review Video

Hey Kenny, yes the Dexter Equalizer kit part #K71-359-00 will work on your 2009 EZ Loader trailer. The dimensions match or in some cases are very close to matching. You wouldn't see any significant differences in geometry or ride height…

After speaking with EZ Loader what you have on your trailer is a 3,700 lb axle. From what they said the axle was upgraded even though your overall trailer capacity is 3,100 lbs. Although this uses the same #L44649 outer and #L68149 inner bearings,…

I have included a diagram below with the measurements of the #K71-359-00 equalizer. The shackle links included with this kit are 2-1/4" long when measured center hole to center hole. The kit is intended for use with 1-3/4" wide…

The Dexter bearing kit part number K71-717-00 that you referenced is the bearing kit for a number 84 spindle. Our part number for that bearing kit is #BK2-100.

I have tried to contact and have left many messages for EZ Loader to get the information on your bearings and seals. Unfortunately they haven't returned any call or email, so the best way to help you is to have you pull one of the hubs off your…

In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first thing you will need to know is the bolt pattern of your hubs. This is so you get a hub that is compatible with your…

Bearings and seals are generally measured in inches. It is best to use a digital caliper, like #PTW80157, and measure out to 3 decimal places to find the most precise figure. I've attached an image that shows how to measure and identify them. As…

Yes, the Grease Seals part #RG06-050 are double lip seals that do have the spring that holds the seal against the spindle. I attached a video on bearing repacking and grease seal installation that you might find informative as well.

Yes, the Bearing Kit #BK2-100 does come with the tang washer and everything you see in the picture I attached. I attached a review video that shows everything included as well.

Although there are standard bearing and seal combinations, sometimes (especially on older trailers) the "correct" seal won't fit, as you have found out. The closest seal that we have to the 1.654 Inner Diameter (ID) that you measured is…

The Hub Bearing Kit for Lippert, Dexter, and Al-Ko Axles - 3,500 lb with #84 Spindle #BK2-100 falls under the etrailer brand. This kit includes the common bearings and seal for a standard 3,500 lb axle.

The #168233 Double Lip Grease Seal has an outside diameter of 2.332 inches and an inside diameter of 1.688 inches. This seal is not compatible with a AF2527E seal with a O.D 2.312, because, even though the O.D. id very close, the inner diameter of…