Review of TorkLift Camper Tie-Downs - Talon Frame Mounted Aluminum Front Camper Tie Downs - TLF2018A Video

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

Yes! I went ahead and attached the installation instructions of the Demco Underbed Rail and Installation Kit #DM8551004 (Demco part 8551004) to this answer.

I really like the Curt Trailer Hitch Receiver #C14108 for your 2005 Chevy Silverado 2500HD Short Bed because it has a hidden crosstube and is a Class IV rating so it's nice and sturdy for up to 10K trailers or 12K trailers if a weight…

The #TLC3205 you have now is only designed to work with the factory hitch. Whether it is the #DT45517, a Curt hitch, or even a TorkLift hitch you will need a different rear tie-down. The correct rear tie-down for a 2002 Silverado 2500 without a board…

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

I would love to help you with this Adam, but I am going to need a bit of information on your exact setup to determine what all you will need. Can you tell me how heavy your car trailer is when loaded and how much extension you will need? Also I will…

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

Hey Robert, sorry it can be a bit confusing navigating all those facets for the camper tie downs, but I did go ahead and find those tie downs you were looking for. For the front, you'll want the TorkLift Camper Tie-Downs #TL87CR (TorkLift P/N…

Unfortunately we do not have a video of the HappiJac Truck-Mounted Camper Tie-Downs #LC184089 being installed. The Rear anchors are installed in the end of the bumper. There is no precise mounting location since a variety of bumpers may be installed.…

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…