Review of Ultra-Fab Products Camper Jacks - 3,500 lbs A-Frame Jack - UF97FR Video

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack…

The diagram you attached shows a 7-way wired up in what is considered the "traditional way." If you check out the chart I attached you will see the three ways (really only 2), that a 7-way can be wired. The Featherlite is wired up…

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs…

I looked through all of our available manual A-Frame trailer jacks and the option with the shortest retracted bracket height is the etrailer.com A-Frame #TJA-2001-B. The retracted bracket height is right at 5-1/8 inches from the ground and it has a…

I recommend the Fulton XLT Powered Drive Trailer Jack #F141401 for your trailer. This jack will fit 3" to 5" trailer tongues and bolts to the side of the tongue since you do not have an A-frame style connection. The jack has a lift…

You can install a larger tank but that is all based on the space you have in your camper/RV and whether or not you're willing to possibly cut a bigger cutout hole in the wall of your camper/RV. An in stock alternative to the #DMC74FR would be…

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

I do have an option for you but we can't confirm Bulldog jack caster wheels will work with a Ram Series 2000 Trailer Jack. That said, we do offer caster wheels for this jack, the Ram Removable, 6" Poly Caster Assembly for 2" Jack Tube…

I recommend the Ram Removable, 6" Poly Caster #JC-101. The caster wheel has a weight rating of 1,200lbs and will fit on your RAM jack with the lower tube outside diameter of 2".

Yes, I went out to our warehouse for you and can confirm that the Ram Removable, 6" Poly Caster Assembly part #JC-101 will fit the Electric Jack w/ Footplate part #EJ-3520-BBX. Please note that using this wheel on your jack will reduce its…

It sounds like you are looking for a caster wheel for a trailer jack. If that is the case then we do have some options like the Ram Removable Assembly part #JC-101 for a 2" outer tube and 1-3/4" inner tube.

Fulton's Snap-Ring Swivel Jack #FTJ120W0301 fits on a snap ring mount with a pilot hole diameter of 2.313-inches. If this matches you're good to go. If not you might consider just installing a castor wheel on your existing jack. If you…