etrailer Electric Jack with Footplate and 7-Way Plug Review Video

Hi Charles, The screws you have in the picture are the ones needed if you were mounting the camera #FOS07TASF into an already mounted shark fin camera mount. If you don't have a prepped trailer with the mounts already in place then…

That is a good question, but no type of special inverter is required in order for you to use the Go Power AGM RV Battery - Deep Cycle - Group 27 - 12V - 100 Amp Hour #34276285. This battery is absolutely compatible with a standard inverter so you…

The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX uses a 7-way RV-style plug. I have included a diagram that shows the pin-out for RV style 7-way plugs. This will show you what each pin does. I have also listed the functions below and…

The Electric Jack #EJ-3527-BBX, and other jacks that operate from power supplied from the 7-way plug, rely on the ground and 12VDC contacts to deliver operating power requirements. Those contacts are located, respectively, at the 5:00 and 11:00…

To add an electric trailer jack to your 2006 Jayco Jay Flight 31BHDS I recommend using one of the following depending on if you want to tie the power into your trailer battery bank or not: - Battery Bank #EJ-3520-BBX - 7-Way Power #EJ-3527-BBX Both…

The SuperSprings Custom Suspension Stabilizer and Sway Control Kit part #SSA22 is a confirmed fit for a 2019 Ford F-250 Super Duty. The springs work to pre-load the factory leaf springs so there will be less squat and saq while towing/hauling. They…

The correct 2,200 lb capacity SuperSprings for your 2017 Ford F-250 4WD is the part #SSA22 that you referenced. These fit with or without the overload springs as well. It is a single leaf spring that matches the width of your leaf springs as well.

Though we do not carry the Hellwig product, from what I could find, the SuperSprings #SSA25 kit will install much the same way. As I wasn't 100% on that, I called over and spoke to one of the Techs at SuperSprings and they confirmed that it would…

I recommend using the Electric Jack w/ Footplate #EJ-3527-BBX that you were looking at because it will easily handle the 7000-lb GVWR of your Winnebago Minnie 2201DS. This jack does not require any wiring since it will plug into your vehicle's 7…

The manual emergency crank for the etrailer.com Electric Jack #EJ-3527-BBX (which is included) requires a 3/8" socket for operation. I have attached a short video review on this jack that you can check out as well.

The Ultra-Fab Protective Cover for Electric A-Frame Jacks - Vinyl - 12" x 14-1/2" #UF38-944020 is the protective cover I recommend for your DISCONTINUED Husky Brute Trailer Jack HT87247. I've attached a photo of the dimensions when laid…

Yes. A 3,000 pound electric jack will work just fine. Based on your trailer weighing 7,500 pounds loaded will equate to your tongue weight between 750-1125 pounds. Although you can choose a 2,500 pound (see link attached) electric jack, I would…