etrailer Electric Jack with Footplate Installation - 2011 Forest River Flagstaff Classic Super Lite Video

Hi Tom, I have two options to replace the electric tongue jack on your Jayco Whitehawk: Option 1: Electric Jack w/ Footplate #EJ-3520-BBX. This jack is going to be your no-frills 'get the job done' style jack. It has a 3,500lb capacity and…

If you check out the picture I attached you can see how the wires of the Ram jack switch #EJ-3520-PSW are supposed to be ran to it.

If you take a look at the diagram I've provided for the Replacement Power Switch for RAM Electric Trailer Jack with Footplate #EJ-3520-PSW which goes to the Electric Jack w/ Footplate #EJ-3520-WBX, you'll be able to see how both of the…

Sounds like there is an electrical short somewhere in the jack circuit. Inspect the trailer jack wiring to see if there is any loose connections and frayed or damaged wiring that could be shorting causing the fuse to blow. Also, if the jack has been…

The trailer jack should very much NOT be powered by the breakaway battery. That was likely done by the previous owner for convenience. The breakaway battery is a dedicated battery for the breakaway system only. It needs to be able to apply the…

It is very likely, although we do not have any types of parts list for each year, make and model of trailer to tell you if the Electric Jack #EJ-3520-BBX will fit your Jayco Jay Flight Travel Trailer. There is a simple way for you to find out; just…

It sounds like you may need an electric jack with a 2-1/4" outer tube diameter and 2" inner tube diameter such as Electric Jack #EJ-3520-BBX. This jack has a 3,500 lb lift capacity, with a 9" retracted height and 28-1/2" extended…

Yes, I went out to our warehouse for you and can confirm that the Ram Removable, 6" Poly Caster Assembly part #JC-101 will fit the Electric Jack w/ Footplate part #EJ-3520-BBX. Please note that using this wheel on your jack will reduce its…

The Electric Jack w/ Footplate part #EJ-3520-BBX is my recommendation for an electric trailer jack replacement for a Jayco Eagle Pop Up Camper. It will be a direct bolt-on swap. It has a 3,500 lb capacity which will be more than enough. It has a…

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

Due to the importance of a properly functioning break away system, it would be best to leave the existing break away battery in place and add an additional battery for powering the jack. A standard automotive or small deep-cycle 12 volt battery would…

The dimensions of the Electric Jack w/ Footplate #EJ-3520-WBX are demonstrated in the attached picture: Front edge - 1 inch Either side edge - 4-5/8 inches Back edge - 5-1/16 inches