Stallion Camper Jack - Stabilizer Jack - 288-01892-2 Review Video

As you can see by the accompanying photos, the Stallion Stabilizer Jacks #288-01892-2 are very similar to the Atwood 82298 jacks. They are drop leg jacks with 7 inches of drop leg travel, an extended height of 22-1/4 inches, a lift capacity of 650…

The Ark stabilizers won't affect your ground clearance, but to determine the right ones that really depends on how high up your frame is off the ground. Overall, the Ark RV Stabilizer Jacks #ARK34FR are 16.6" collapsed and…

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer…

Since the tongue of your trailer flares out you could just cut a piece of wood to match the angle of the flare to square up the tongue and then clamp-on the etrailer Round/Wheeled Swivel Jack #e79CR. If the trailer stays outside a majority of the…

I have attached a few photos for you with all the dimensions we have for the Ark Drop Down Corner RV Stabilizer Jacks part #AR34FR. That said, Ark is an Australian company so the measurements are in metric, millimeter to be specific so you may need…

I attached an install video for a similar set of stabilizer jacks to the part #288-01892-2 for you to check out. The trick is you swing the jack to the side which allows you access for hardware through the bottom of the mounting plate.

The weld-on mounting bracket for the ARK #AR94FR Drop Down Corner RV Stabilizer Jacks measures 4-5/8 x 2-7/8 inches. The bracket has holes for the hardware that attaches the jack to the brackets. The holes are 2-7/8 inches apart on center. I've…

You are correct. You will want to use the backing plate to sandwich the boards and provide the most secure connection when installing the Brophy Swiveling D-Ring Anchors #RR6K-4 . You can mount these in a recessed hole created by a router or punch…

The Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs #RR5K are rated for 5,000 lbs break strength and will work just fine with your application. The 3/4 inch plywood floor is very strong and with the…

Thank you for the kind words, the K-Source Snap & Zap Custom Towing Mirrors #KS80930 are confirmed to fit all models of the 2021 GMC Sierra 1500, that would include the Denali. The mirrors have a cut out in the bottom that fit around the…

Yes, we do have towing mirrors for a 2022 Chevrolet Silverado. I recommend the K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side item #KS80930. I personally drive a Silverado and I think some of the towing mirrors…

Quality-wise there isn't much of a difference between the etrailer.com stabilizer jacks part #TJ01RT-HD and the Stallion Stabilizer Jacks #288-01892-2 that you also mentioned. I'd recommend going with the kit that matches the height…