Customers compare 165863 to these similar products
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
Yes, the Washer Spindle Tongue part #165863 will work with 7/8" diameter spindles. If you also need the castle nut and cotter pin as well we have these available as part #165931 and part #165649.
view full answer...We have a few washers that would work for you. If you want the tang style that can be bent over the notch in the castle nut, go with #5-101. If you're looking for the D washer used on EZ lube spindles, use part #5-23. For a spindle with the…
view full answer...I would recommend to use the treated torx screws for ACQ (Alkaline Copper Quaternary) treated wood for better corrosion and rust resistance. The treated torx screws like the Redline 2-1/2 Inch Long Torx Trailer Screw for ACQ Treated Wood, part…
view full answer...The TruRyde Replacement D Tang Spindle Washer #5-101 that you referenced has a 1-inch inner diameter to fit on 1-inch diameter spindles. All such items that we offer share this same 1-inch inner diameter, such as parts #5-23 and #5-57. The points on…
view full answer...For your replacement Dexter hydraulic brake assemblies, you will want the Dexter Hydraulic Trailer Brake Kit - Uni-Servo - 10" - Left and Right Hand Assemblies #23-312-313. These will work very well with your existing hub/drum assemblies.
view full answer...You will need to remove your hub, remove the seal and get the bearing numbers and seal numbers from what you have right now and then you will be able to pick out the correct kit. I attached a picture that shows bearings, races, and seals where you…
view full answer...Even when stored in the somewhat controlled environment of a garage, tires are still subject to dry rot and flat spotting. Even if the tire tread has plenty of depth left and you can't see any cracking with the naked eye, the generally accepted…
view full answer...To find the correct replacement hubs I would need to know the inner and outer bearing numbers stamped into the sides of the bearings. If the spindle is straight, meaning both bearings have the same inner diameter, then it probably takes a hub with…
view full answer...The Dexter Trailer Hub Assembly you referenced, part #AKIHUB-440-2-1K is known as an idler hub. An idler is a hub that is no provisions for trailer brakes. It has no brake drum. Part #8-276-5 is an example of a hub/ drum that has a brake drum that…
view full answer...Part #GS-2125DL seals are double lip seals and have the same dimensions as the single lip seal. The double lipped seals retain the grease inside the hub and help keep water and dirt out better than the single lip seals.
view full answer...The washer measures just under 1/8 inch thick and the OD is 1-3/4 inches and the ID is 1 inch. The tongue inside measures about 5/32 inch square.
view full answer...You'd want the tang washer like the #5-101 that you referenced between the washer and the nut.
view full answer...