Review of Mount-n-Lock RV Safety Struts - MO22FR Video

The Mount-n-Lock SafetyStruts Universal Kit #MO34VR includes the Standoff Spacers #MO54VR along with drill bits and the components found in the Standard Kit #MO22FR. The standoff spacers allow for mounting on I-beams shorter than 6".

From how you're describing your set up, it sounds like your bumper is attached to a tube frame, and there is a way for you to install the support brackets, which are the following part number: - Mount-n-Lock SafetyStruts Universal RV Bumper…

You could weld the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames #UF35-946403 to the box frame that's welded to the frame of your 2019 Grand Design Imagine 2600RB travel trailer but would need to have a fabricator come out…

In order to choose the correct Torflex Lift Kit for your 2015 Retro Riverside Trailer, you will need to determine the type of axle that it has. We have a couple of single axle lift kits currently available from Torflex. If you have a #9 Torflex…

All of our cargo carriers like the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 you checked out all come with the support brackets. Currently, we do not offer the cargo carrier without the support bracets.

The Safety Struts you have now on your RV frame/bumper would work well with the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 that you mentioned. You can use them instead of the brackets that come with the carrier and you'd be…

Thanks so much for that detailed info, and we do indeed have a trailer hitch for your Jayco trailer with an I-beam frame with a 68 inch inside width, from Curt: - Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide…

Many RV bumper manufacturers construct their product with a plastic cap or a hinged door instead of endcap, allowing bumper to be used for storage; apparently you have this type. Open that end piece to examine if the seam has spot welds (short welds…

The Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets - 4" to 4-1/2" #MO34VR will increase the RV bumper's weight capacity to 400lbs. This will fit 4" - 4-1/2" bumpers which looks to be what is on the 2017 Avenger…

Yes, the Trailer Bumper Hitch Receiver, part #E-100, can be used on towable pop-up camper units with up to a 4 inch square bumper. However, you cannot exceed the limits of your camper bumper. The bumper towing and tongue capacities may be indicated…

I went out to our warehouse and measured the thickness of the L-Brackets on the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames #UF35-946403 and measured .34" or 11/32" thick. As per the second question, you are not going to be…

You'd need to box the I-beam frame where you plan to install the Ultra-Fab 2" Trailer Hitch Receiver #UF35-946403 and then you can weld it in place. You'd need to weld around the L-bracket basically of the hitch to the frame. See…