Trailer Hitch For Camper Trailer With I-Beam Frame With 68 Inch Width  

Normally the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets #MO34VR install on outsides of trailer frame. I attached an install video for this for you to check out as well.

From how you're describing your set up, it sounds like your bumper is attached to a tube frame, and there is a way for you to install the support brackets, which are the following part number: - Mount-n-Lock SafetyStruts Universal RV Bumper…

The Mount-n-Lock SafetyStruts Universal Kit #MO34VR includes the Standoff Spacers #MO54VR along with drill bits and the components found in the Standard Kit #MO22FR. The standoff spacers allow for mounting on I-beams shorter than 6".

You could weld the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames #UF35-946403 to the box frame that's welded to the frame of your 2019 Grand Design Imagine 2600RB travel trailer but would need to have a fabricator come out and look…

The Safety Struts you have now on your RV frame/bumper would work well with the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 that you mentioned. You can use them instead of the brackets that come with the carrier and you'd be perfectly…

All of our cargo carriers like the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 you checked out all come with the support brackets. Currently, we do not offer the cargo carrier without the support bracets.

Many RV bumper manufacturers construct their product with a plastic cap or a hinged door instead of endcap, allowing bumper to be used for storage; apparently you have this type. Open that end piece to examine if the seam has spot welds (short welds…

In order to determine the capacity of the rear bumper on any fifth wheel trailer you'll need to reach out to the trailer manufacturer as we don't have this information. That said, it's typically around the 200 lb mark. If you need/want…

I have another option that may work for you, but Unfortunately the brackets on the #13703 cannot be flipped which my contact at Curt confirmed. The Adjustable Width Trailer Hitch Receiver for RVs, 22" to 66" Wide #C13704 can be bolted or…

I went out to our warehouse and measured the thickness of the L-Brackets on the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames #UF35-946403 and measured .34" or 11/32" thick. As per the second question, you are not going to be…

Yes, the Trailer Bumper Hitch Receiver, part #E-100, can be used on towable pop-up camper units with up to a 4 inch square bumper. However, you cannot exceed the limits of your camper bumper. The bumper towing and tongue capacities may be indicated…

Since your bumper is welded to the frame, it should be very strong and likely won't need to use the support brackets #MO34VR for the 24x60 etrailer Cargo Carrier for RV Bumper #e99049. However, you'll want to verify that the load you're…