Review of InfiniteRule Locking Pins Lock N Roll Articulating Hitch 2" - IR59FR Video

For a hitch pin for the Lock N Roll Articulating Hitch w/ 3-Position Channel #336VS503505 I recommend the InfiniteRule Locking Pins for Lock N Roll Articulating Hitch for 2" Hitches - Qty 2 #IR59FR. This set of pins is specifically designed for…

Although the Lock N Roll Articulating Trailer Coupler for 2" Receivers #336TS510 has a 5/8" pin hole to secure it to your trailer, you can definitely weld this to your trailer instead. Just be sure the work is done by a qualified welder…

There is a trailer coupler designed specifically to be used for offroading, from Lock N Roll. This uses an articulating connection between the coupler and accompanying hitch mount that gives a full 360 degree rotation between the two. So the trailer…

The vehicle side of the Lock N Roll Articulating Trailer Hitch #336VS501 can be locked to the vehicle's 2-inch receiver hitch using any standard pin lock such as #e98880. The mating part that bolts or welds on to the trailer #336TS508 will only…

I spoke with my contact at Lock N Roll about the Lock N Roll Articulating Hitch part #336VS503505 and they were not quite sure what measurements you are looking for nor was I. That said, I went out to our warehouse for you and jotted down a few…

The #336VS503515 comes with the adjustable channel bracket along with the adjustable channel mount and bolts. You will need to install the channel mount in the appropriate rise/drop position since it does not come fully assembled. It looks like you…

The three sizes of electric trailer drum brakes you referenced, 7-, 10- and 12-inch diameters, are intended for different axle weight capacities. Since each size will presumably have a proportionate weight load it has to stop, their wear rates will…

Good question, and the hitch on your Audi is not rated for use with weight distribution, so what I recommend instead is a friction sway control set up. This will provide you with better control over your trailer to give you a much more controlled,…

I had our warehouse measure the Lock N Roll Articulating Hitch for 2" Receivers - 4-1/2" Drop/Rise #336VS517 you were looking at, and from the center of the hitch pin hole to the center of the hole that the pin on the trailer side connector…

I'm assuming you're speaking of a 2 inch drop on the ball mount you're currently using, is that correct? If so, the #336VS503505 Lock N Roll articulating ball mount you'd looked at would allow for a 2 inch drop to properly level your…

The Lock N Roll Articulating Coupler #336TS502 will come with two 5/8" grade 5 coarse thread mounting bolts and lock nuts. These bolts have a recommended torque spec of 112 lb-ft.

In order to get this setup, you want to start with the Lock N Roll Articulating Trailer Hitch for 2" Receivers #336VS501. This will fit the 2" receiver on the hitch on your vehicle. For the trailer side, you will need to remove the current…