Heininger Holdings Boat Trailer Parts - Step - HE4036 Review Video

I attached a picture that has the dimensions of the U-bolt part #CE15504A shown so that you can see the inside, center, and outside widths.

We have seen people mount storage boxes on either side of the nose of a V-nose trailer like what you see in the picture I attached. The part #DZ91717P would work well if you have room for it like that. The dimensions of the box are 36"…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are…

What you are looking for is the supply hose that runs from the regulator to the splitter. So for that we have 6 foot options like the part #100040-72-MBS which use the standard 3/8 inch fittings on both ends. I also attached a link to a page that…

Though we do not have the exact 1.5 inch by 1.983 inch we do have The Grease Seals (pair) #RG06-020, which is slightly bigger and will work for you. This grease seal pair will work with E-Z Lube 2,000 Pound Idler Hubs. The I.D is 1.500 inches and…

The grease seal you need is the part #34823. 4 thousandths of an inch is a tiny amount and realistically it's within the margin of error on the caliper you are using. This seal will work just fine and is the correct one for the hub you…

There are really two reasons to replace a grease seal, if they are damaged or worn and leaking grease then that is an obvious factor. If you are replacing bearings it is usually best to replace the grease seals as well because although they may…

It sounds like you are trying to add some steps to the tongue of your boat trailer for help getting in the boat. If that is the case then only bolt-on option we'd have is the HitchMate Boat Trailer Step part #HE4036 which bolts onto the…

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

The HitchMate Boat Trailer Step #HE4036 does only come as powder coated steel. This will offer corrosion resistance, but it will also need to be kept clean to keep this up. We do have a galvanized step available, but it is a different design. The…

The HitchMate Boat Trailer Step part #HE4036 should fit with a swing up jack depending on where you place the step. The retracted height of the Fulton Bolt-Thru Swivel Marine Jack - Bolt On - Sidewind part #FXP15L is 26" so you may be able to…

The core of the wiring that comes with the LED Combination Tail Light Kit #TLL9RK that you referenced is stranded copper. I attached a review video for more info on this kit.