Review of Fastway Weight Distribution Shank - FA92-02-4214 Video

Eight inches from the ground to the bottom of your weight distribution shank would be fine for most situations but like you've experienced turning into inclined driveways can cause it to drag. Your trailer must sit pretty low to call for your…

Your weight distribution system uses a Shank #FA92-02-4100 that gives you a maximum 6-1/4" of rise and 2-1/4" of drop. I recommend using the Fastway Shank #FA92-02-4214. This will give you up to 10" of rise and 7-1/4" of drop with…

The measurement from the top of the Fastway e2 Shank, #FA92-02-4214, to the center of the top first hole is 3-5/8 of an inch. Each hole after this first hole will be an 1-1/4 inch apart. The last hole or the bottom hole furthest from the hitch shank…

When it comes to installing a weight distribution on your 2019 Chevrolet Silverado 2500 when towing a 24 foot 10,000 pound car hauler I recommend The Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion - 12,000 pounds GTW, 1,200 pounds…

If you need a few more inches of rise or drop the shank you would want is the part #FA92-02-4214 which has a height of 11-1/2 inches instead of 9 inches like what you said your current one has. I attached a picture that has the dimensions of this…

The correct replacement hardware kit for your Fastway e2 4.5k system is the Replacement Hardware Kit for Fastway e2 Weight Distribution Head #FA92-02-9600. The Replacement Bolts for Equal-i-zer Weight Distribution Head #EQ90-02-9400 you asked about…

USB chargers like the Charging Station for RVs #DG61031VP draw approximately 0.05 watts when not in use.

Yes, the Equal-i-zer Weight Dist Shank part #EQ90-02-4900 will work with the Fastway E2 weight distribution system such as the Fastway e2 Weight Distribution w/ 2-Point Sway Control part #FA94-00-0600. As long as the 10" of rise and 6" of…

Based on the pictures you attached (thank you!) it looks like you have the Equal-i-zer Weight Distribution Shank #EQ90-02-4100 that allows for a drop of up to 3 inches from the top of the hitch receiver opening. The adjustment portion of the shank…

First, I recommend looking at the owners manual and hitch for your 2006 Toyota Highlander to make sure that both can be used with weight distribution. To choose a weight distribution system you will need to go by the total tongue weight of the set…

The dimension you are looking for is 3-7/8 inches. This is the distance from the top of the shank down to the first hole on the Fastway Shank part #FA92-02-4214

Fastway has a longer weight distribution shank that has more drop like you need with the part #FA92-02-4214 which can do a drop of up to 5-1/2 inches and is 12 inches long. Or if you need more drop than that we have the part #FA92-02-4315 which is 12…