Fastway e2 Weight Distribution System Installation - 2019 Toyota RAV4 Video

We sure do! It looks like your TAB 320 S Tear Drop Camper tops out a 3,000 lbs which would give it a tongue weight range somewhere around 300 lbs depending on how you load it. For a surge brake compatible weight distribution system, I recommend the…

The adjustment of any friction sway control system, including the Reese #83660, is relatively simple. Basically, you will drive with the trailer loaded to determine if more or less tension is needed. Then you will either make it tighter or looser my…

We don't have a combo of the Curt Hitch Ball #C40008 and Curt Ball Mount #C45340. The ball mount is extremely heavy-duty, rated up to 17,000 pounds. I think it's safe to assume you don't have a torque wrench rated up to 450 foot pounds…

Ideally, you will want both your tow vehicle and boat trailer to be as level as possible when towing. Some of this will depend a bit on the tongue weight of the trailer you will be pulling. For example, a trailer with a heavy tongue weight may…

I would not think in Spain or France that they would use foot pounds since it isn't a metric measurement. But regardless I checked with Curt and the 450 foot pounds is what you would need.

Weight distribution hitches are designed to be able to move up and down because you are going to run into situations like this everywhere you go. So no worries about it stressing the system. The back of the trailer is less likely to make contact with…

Based off of the truck weight rating information you have told me, as long as you stay under 650 lbs of tongue weight the truck is capable of towing the 4,700 lb trailer. Using a weight distribution system does not lower the tongue weight of the…

First, I recommend looking at the owners manual and hitch for your 2006 Toyota Highlander to make sure that both can be used with weight distribution. To choose a weight distribution system you will need to go by the total tongue weight of the set…

When it comes to installing a weight distribution hitch on your travel trailer which weights 3,877 fully loaded you will need a weight distribution system and I recommend The Fastway e2 Weight Distribution #FA92-00-0450. This weight distribution…

The measurement from the top of the Fastway e2 Shank, #FA92-02-4214, to the center of the top first hole is 3-5/8 of an inch. Each hole after this first hole will be an 1-1/4 inch apart. The last hole or the bottom hole furthest from the hitch shank…

Fastway has a longer weight distribution shank that has more drop like you need with the part #FA92-02-4214 which can do a drop of up to 5-1/2 inches and is 12 inches long. Or if you need more drop than that we have the part #FA92-02-4315 which is 12…

If you need a few more inches of rise or drop the shank you would want is the part #FA92-02-4214 which has a height of 11-1/2 inches instead of 9 inches like what you said your current one has. I attached a picture that has the dimensions of this…