Draw-Tite Wiring - Trailer Connectors - 18004 Review Video

Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…

Your 4-pin/5-wire wiring harness is what is called a "wishbone" type which simply means that there are two separate running light wires, one brown and one pink. This allows a separate running light wire for each side of the trailer…

You will first want to check the fuses on your tow vehicle. Some vehicles could have fuses for operating the turn signals and brake lights of a towing package. You will want to check if they are installed and working properly. The next thing is to…

As for the white ground wire that you mention, this wire should be firmly attached to a clean metal surface on the trailer. As the lights are currently working properly, you are most likely picking up the ground connection through the trailer ball.…

The harness part #CR-600L-LED that you referenced is a replacement for the Round Tube Stainless Steel Trailer Hitch Receiver Step with LED Lights #CR-600LED which uses a standard 4-way connection which should be present on your 2017 Chevy…

Part #Y8880203 and #8880161 would be the wiring for the tongue while part #8880162 would be needed for the rear lights. The balance of the wiring is run inside the framework of the Rack and Roll trailer. Since you said you are replacing all of the…

Yes, the Pilot Replacement LED Strip #CR-600L-LED is the correct item to replace the LED lights on your Bully Black Bull LED Round Tube Hitch-Mounted Step #BBS-1104L. The kit includes the LEDs, wiring and adhesive strip.

A 4-Way flat connector has the white wire for ground, brown wire for running lights, yellow wire for left turn and brake, and green wire for right turn and brake. The Peterson Round Trailer Tail Light, part #431800, is a three function light and…

To replace your wiring on your Bully hitch step #CR-600LED I recommend the Hopkins Wiring Harness with 4-Pole Flat Trailer Connector #HM38138 along with heat shrink connectors #DW05743-5. For added protection you can add a wire loom like #7509-1…

If you still have access to the four wires that run to the back of the Bully Black Bull LED Step part #BBS-1104L you can replace the 4-way with a #18004. If you do not have access to the wiring we do not have a solution for you.

There are always new things added to trucks with sensors and such for safety and this is one of the most recent. The workaround for an LED hitch cover like #CR-007G would be to add a load resistor. Some adapters like #C35FR have load resistors…

To splice in a trailer end connector such as the 4-Pole Trailer End Connector #18004 or Hopkins Endurance Easy-Pull Harness w/ 4-Pole Flat Connector - Trailer End #HM38134 you will need to match the connector to your wires by function. On these…