Draw-Tite Ball Mounts - Adjustable Ball Mount - 7390 Review Video

If the truck had a factory 7 way installed at the factory, it should be plug and play. If the 7 way was installed at the dealer, it may be missing a fuse or breaker. The 12V trailer charge is a separate circuit. That is to supply power directly from…

The Ford Explorer and Mercury Mountaineer have 6-pin connectors behind the glove box on the passenger's side that you would use for the installation of a brake controller with the #3035-P. I attached an install video that shows where it is as…

The length from the pin hole to the ball on the #C45056 Curt Class III Ball Mount with 2" Ball - 4" Drop - 2" Rise is approximately 8-1/4". I have attached an image from Curt showing the dimensions as well as a video review for…

The 2009-2018 Ford Edge Sport can only tow 2,000 lbs safely. This is not due to sway control lacking but is the rating based on engine, transmission, frame, and suspension. The 2019 and newer models have a higher rating of 3,500 lbs. Unfortunately…

We have just the thing! The Replacement Male Pipe #TJP-IP916 is going to be the correct weld-on male pipe mount for the #TJP-5001S-B jacks. If you need the female side to weld to the jack itself it will be part #TJP-OP916.

Yes, the Reese Sway-Control Bracket #RP26003 that you referenced will fit with a 2-5/16 inch hitch ball. The confusion may be that this is designed to fit 2 inch ball mounts. That means ball mounts designed to fit 2 inch hitches. As long as the…

Yes, you can use the Reese Sway Control Bracket #RP26003 on the MaxxTow Adjustable Ball Mount MT70067. For a sway control unit I would go with a Reese Friction Sway Control Kit #83660 as it is designed to work on the Reese Bracket #RP26003.

It wouldn't ever be necessary to put a rise into the ball of a sway control setup. So what that means Barry is that since the ball always mounts to the side of the ball mount platform it basically will always be at the correct height. I attached…

A standalone friction sway bar like the Curt #17200 that you referenced is an excellent sway control alternative for vehicles like your 2018 Audi Q5 that aren't rated for a weight distribution system. You are correct that a full weight…

The female version of the Bulldog Replacement Pipe Mount for Swivel Jacks #BDPQM1900 isn't available separately and only comes already installed on the trailer jacks, like what we see with part #BD195362. If you're needing a weld-on bracket…

Your 2018 GMC Acadia actually has blunt cut wires for you to splice in a brake controller like the Tekonsha Prodigy P3 #90195. The last Acadia to use the Adapter #3026-P that you referenced was the 2017 Limited which was the same as the 2016 model…

On a GMC Acadia, there is a trim panel below the dash and above the brake pedal. You will start be removing this panel carefully. There is a light attached to it so pull it down slowly so you do not break the light. With the panel out of the way,…