Weld-On Pipe Mount For The TJP-5001S-B Round Pipe Mount Swivel Jack

Question

Question:

I have multiple jacks of TJP-5001S-B but what I want to do is find the weld on mounts that fit those so I can weld on to another trailer. I sold my last trailer but kept my TJP-5001S-B jacks. Can you provide the product number for those round mounts please? Thank you

asked by: Todd E

0

Expert Reply:

We have just the thing! The Replacement Male Pipe # TJP-IP916 is going to be the correct weld-on male pipe mount for the # TJP-5001S-B jacks. If you need the female side to weld to the jack itself it will be part # TJP-OP916.

expert reply by: Jesse M

0

Answer 1

It sounds like you're looking for the Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00 for 2-3/8" diameter axles. This comes with everything you need to relocate your axle to underneath your leaf springs for a standard…

view full answer...

Answer 2

The female version of the Bulldog Replacement Pipe Mount for Swivel Jacks #BDPQM1900 isn't available separately and only comes already installed on the trailer jacks, like what we see with part #BD195362. If you're needing a weld-on…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 6

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 7

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

Hey there Gary, thanks for the photo and yes the etrailer Bolt-On Swivel Mounting Plate for 3,500-lb Trailer Jacks with a 5/8" Swivel Pin #e52JR will indeed work with your Round, Pipe Mount Swivel Jack #TJP-5001S-B.

view full answer...

Weld-On Pipe Mount For The TJP-5001S-B Round Pipe Mount Swivel Jack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching