Demco A-Frame Trailer Coupler - Standard Coupler - DM14793-95 Review Video

I reached out to my contact at Demco who was able to supply me with the attached dimensional photo of the Demco A-Frame Trailer Coupler #DM14793-95.

That is correct the inner dimension of the Demco A-Frame Trailer Coupler item #DM14793-95 is 10 3/4 inches. I have attached a picture that breaks down the measurements. You would need to fabricate a spacer on either side to attach this coupler to…

The Demco A-Frame Coupler #DM14791-97 will fit the fairly standard 50 degree A-Frame, which you do look to have. This will definitely extend farther than your current coupler and will measure 7-1/2" long (roughly) from where the A-Frame…

The Demco A-Frame Trailer Coupler #DM14793-95 is designed for standard A-frame trailers which is 50 degrees as you mentioned. I confirmed this with my contact at Demco. This is a 10,000-lb coupler and it is designed for a 2-inch hitch ball.

I've attached the dimension pictures you requested for the #37220BL. Let me know if you would like any other dimensions and I'll get them added in.

The Lippert part number 173552 you referenced comes back to the Lippert Manual Pull-Out Step for RVs #LC432682. Because there is a bit of cross over with these item numbers it's best to take a quick measurement of what you currently have to…

Your 2016 Wildwood camper was made by Forest River which typically uses Lippert frames, so the Lippert pull out steps part #LC432682 should work well for you. However, you can measure your current steps and compare them to the dimensional pictures…

Yes, everything you mentioned is compatible. The spindle part #TRU74FR is compatible with the hub/drum part #AKHD-545-35-EZ-K which is also compatible with the brake assembly set you mentioned of #AKEBRK-35-SA. The bearing kit part #BK2-100 is…

Although it's intended to be bolted in place, the Demco #DM15349-52 coupler mount could certainly be welded instead. I've linked you to a product description video featuing the #DM15349-52 A-Frame coupler mount.

There is! To replace the standard pin and clip on the Curt QuickPin No Latch A-Frame Trailer Coupler #C84DR Curt actually recommend the Hitch Lock #C23025 which is what I recommend going with!

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions for attaching the…