Review of CURT Trailer Hitch Ball Mount - Adjustable Ball Mount - C89NR Video

The distance from the top of the shank to the bottom of the hitch ball at the lowest setting on the Curt Adjustable 2-Ball Channel Mount part #C45927 is 14-3/8". I went out to our warehouse to measure this for you.

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

The Extang #EX1032 replacement hinge that you referenced is made for Extang Trifecta and Extang eMAX folding tonneau covers as a hinge replacement. I reached out to my contact at Extang and found out that they also make the Gator covers and that…

We have 12 inch drops and we have 14 inch drop ball mounts but we do not have a 13 inch. Going an inch lower would be better than an inch higher though. But you did say that the 12 inch drop put your trailer 1 inch lower than that your hitch so…

The largest drop available is 17-1/2 inches with the Gen-Y Adjustable 2-Ball Mount w/ Stacked Receivers - 2" Hitch - 17-1/2" Drop #325-GH-318, which has such a significant drop that you will need the Adjustable Stabilizer Bar Kit…

It's not likely your International has a factory connector for an electric brake controller adapter. But you can still install a Prodigy P3 #90195 by hardwiring it into the RV. You will wire the P3 in by connecting the black wire to the positive…

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

Curt has a recommended setup procedure outlined for the Curt Echo part #C51180 that is outlined in their install instructions for this controller but since not all trailer brakes apply the same way there isn't a standard setting you can use that…

In regards to ball mounts such as the Flash Solid Steel Adjustable 2-Ball Mount #FA49-00-5900, rise is the distance from the top of the shank to the top of the ball mount platform when oriented for rise (please see accompanying photos). The Flash…

Weight distribution shanks offered from Curt, Reese, Equal-i-zer, Fastway etc will typically be interchangeable. However, the shank used on the #FA49-00-5900 adjustable ball mount isn't designed for use as a weight distribution shank. Not only…

We aren't manufacturers of those parts, and we don't have the testing ability in house, so I reached out to a couple of our manufacturers to see what information they could provide to try and help. I reached out to my contact at Curt…

WeatherTech does not make a custom fit floor mat for any Class A motorhomes, but you can use the WeatherTech All-Vehicle Mat #61-11AVMOTHSG since it is a universal floor mat that can be trimmed to fit virtually any application. These mats are easy to…