CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE32100G Review Video

The brake is strictly an On/Off proposition. When it's in neutral, the strap can be pulled out easily without the handle turning which is a nice feature. In neutral, the strap can be pulled out, but there isn't any sort of a brake.

The 2-Speed Boat Trailer Winch part #315-W3200D is an excellent upgraded 3,200 lb winch for a boat trailer. In regards to mounting, not all winches use the same pattern so you'd need to compare the dimensions in the photo below to what you have…

To haul two kayaks on a pickup truck rack system that does not over hang past the cab, and does not use the hitch receiver you will need a full rack on the bed of the truck. Consider the Erickson #EM07706 truck bed rack that supports 800 pounds!

Transom savers install by having one end attach to the lower section of your outboard motor and the other end goes to some point on the trailer. Typically a roller. The CE Smith Spool Roller Assembly part #CE32100G would work well for this.

Though the leaf springs are rusty, they do not seem to look pitted, so they should still be fine. It wouldn't hurt to clean them off with WD-40 or a rust remover to make sure they don't get worse. If you did want to replace them though, you…

First, roller with bracket #CE32100G is not going to work because the mounting holes on it are spaced 3 inches apart on center so it would be too wide. It measure approximately 2-1/2 inches from the bottom of the bracket to the center of the shaft.…

I went out to the warehouse to measure the internal width of CE Smith roller #CE32110G. It measure 1-7/8 inches. I have included a picture showing this measurement for you.

We do not offer U-bolts for the CE Smith Offset Spool Roller Assembly for Boat Trailers - Galvanized Steel w/ Black Rubber - 4" #CE32110G, and the mounting holes for these are 2-1/2" apart on center and there is a better option for you. I…

We don't offer a flat roller assembly, but the 5 inch #CE10401G assembly has a roller that's more flat that might work well for you. The flatter profile would spread more of the boat's weight out over a larger area.

There sure is! If you use the provided links, you can see both the owner's manual which shows how to use the system as well as the installation instructions. I'll also link to a video showing a typical installation, which you might find…

The Yakima Rack and Roll Trailer #Y08107 referenced in your question can be easily folded for storage in numerous positions, however the wheels themselves cannot fold flat. The wheels though can be easily removed along with folding the trailer to…

Rhino-Rack offers several versions of Nautic kayak carriers like #RR570. These include both side-load and rear-load models, all shown on the linked page. We also carry replacement parts, also shown on a separate link. We also offer their…