B and W Pintle Hitch - Pintle Mounting Plate - BWPMHD14002 Review Video

It sounds like you have a trailer taillight that grounds through the mounting hardware. Typically the red wire would run to the turn signal/stop light circuit and the black would run to the taillight circuit, and then the ground circuit would be…

From our experience the military trailer you have uses a standard lunette ring so a pintle hook like the Curt #C48005 would work fine.

Yes, the B&W Pintle Hook Mounting Plate #BWPMHD14002 can be mounted in either the rise or drop position. If you also need a pintle hitch the Curt #C48200 is rated for up to 16,000 pounds when using the pintle hitch. This also included a 2-5/16…

The center to center for the holes on the Demco Spare Tire Carrier for Bolt-On Swivel Jack part #DM15853-52 is 5.5" this is the side to side dimension you mentioned. I have also linked the video giving more in depth specs for you to check out.

I went ahead and checked out the SeeLeveL Sensor for RV Holding Tank Monitor #SE78VR and unfortunately they are not going to be compatible with metal tanks. These sensors will work on most plastic or polyethylene holding tanks that contain…

We have the 710-AR and 710-ES2 SeeLevel sensors, though I was unable to find any 701AR or 701ES2. If you were referring to the 710-AR and 710-ES2 you would need the following: - 710-AR: SeeLeveL Sensor #SE88VR - 710-ES2: SeeLeveL Sensor #SE78VR

Yes, you can hook up a power inverter to input one and then shore power to input two on the Furrion Automatic Transfer Switch part #F30ATS. The dip switch will then need to be in the off position in order for the power to transfer instantly without…

I noticed in the details that they say, "Switches from shore power, or an inverter, to a generator automatically when available. So, in the case that you unexpectedly lose shore power, the switch will automatically begin to run power to your…

It sounds like you have a short in your Power Cord wiring as there isn't anything between the power cord and the Go Power Transfer Switch #34270278 as they are directly wired. I've attached a video of the Go Power Transfer Switch - Quick…

I contacted our Go-Power Rep for this question to ensure we provided you best possible response about the Go Power Automatic Transfer Switch, #34270278. After explaining your question they stated that conceptually this should work the way you are…

The Replacement Rung for Stromberg Carlson RV Exterior Ladder measures 13-1/4" overall length. The diameter of the hole is 1". From the center of one of the holes to the other hole is 11-1/4" and the measurement between the holes is…

The Stromberg Carlson Ladder #LA-401 (Or #LA-401BA in black) is 99-1/2 inches tall and has 250 pound weight capacity. It's also hinged. If the 99-1/2 inches is a little too long for you the ladder can be trimmed to fit your needs.