B and W Ball Mounts BWTS35010 Review Video

No, you can't. I contacted B&W this morning and was told they do not sell the components of their tow and stow ball mounts separately. While you are most likely correct and they are probably interchangeable, B&W wants you to buy a new…

The ETrailer stickers are only on our branded products or on the specific product in the picture/video. So you would only see an ETrailer sticker if you bought one of our manufactured products. Your Phoenix Faucets Catalina RV Tub and Shower Diverter…

Yes. We only put the stickers on for the pictures we take to identify them as our pictures. The ones you receive would not have the stickers. Unless you want them on there!

The distance from the top of the shank to the bottom of the platform on the B&W Tow & Stow 3-Ball Mount part #BWTS10048B while in the stowed position is 8-1/2". I am not sure where you were measuring from but if you measure from the top…

We put stickers on everything we take pictures and shoot videos of. Sometimes they're more obvious than others but they're always there. It's not specifically for branding it's actually to help protect ourselves from getting our…

I spoke with my contact at B&W and the replacement pin for Tow and Stow ball mounts, #BWTS35010, is 5-3/16 inches long overall and it has a 5/8 inch diameter.

Good question, and the hitch on your Audi is not rated for use with weight distribution, so what I recommend instead is a friction sway control set up. This will provide you with better control over your trailer to give you a much more controlled,…

For your 2013 Ford F-150 4x4 with the 3.5L EcoBoost engine, I recommend using the SumoSprings Solo Custom Helper Springs part #SSR-117-47 which are rated for 1,500 lbs. The reason I recommend going with the 1,500 lb system over the 1,000 lb system…

B&W recommends using a pin in their Tow & Stow 3-Ball Mount with 5 Inch Drop #BWTS10048C that is rated at 10,000 lbs. The only locking hitch pins that we carry that specify they are rated for 10,000 lbs and will fit the span of the Tow and…

We do have weight distribution shanks available that are designed to fit 2-1/2 inch hitch receivers like what is on your Silverado 2500. For the Reese Steadi-Flex Weight Distribution System #RP66561 that you were looking at, you will just need to add…

The Anti-Rattle Device and Lock, #63232, is made of chrome plated steel. It does not have an official capacity because it has a higher breaking point than a hitch or ball mount that would be used with it. I have included a link to a video showing how…

It sounds like you are looking for the correct size ball mount for your 2015 Toyota Tacoma in order to tow your trailer level. In order to determine the best ball mount for your setup, you will just need to take a couple quick measurements. Starting…