Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Many times the thickness of the grease seals #RG06-070 is not a factor. If this is a trailer hub there should be enough room for the seal to fit flush with seal flange.
view full answer...Most weight distribution heads have mounting holes spaced 3-3/4 inches apart on center. The shanks have holes spaced 1-1/4 inches apart on center. The head part as far as where the trunnions fit is the same as #RP54980. The exact replacement shank…
view full answer...I spoke with one of my contacts at Taskmaster. I was advised that wheels like the 17-1/2 inch Taskmaster Steel Dual Wheel #1750275WD4 can use any lug nut on them as long as they are flanged.
view full answer...Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…
view full answer...I can certainly point you in the right direction. The Dometic Duo Therm 3107541.009 is a model that we see fairly frequently. Now I do not have literature on your specific camper that will tell me if it is ducted or ductless, but the Advent units we…
view full answer...The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.
view full answer...Like you said the use of a weight distribution system depends on the vehicle specifications. I checked with Tesla and they do not recommend the use of one due to the unibody construction. Weight distribution systems transfer a portion of the weight…
view full answer...Part #PTW2997 works great for charging your breakaway battery when the trailer is not in use. This product is easy to hook up and fairly inexpensive compared to the price of a new battery. I strongly recommend this product. We do not carry any…
view full answer...On Dexter 12" Nev-R-Adjust Electric Brake Assembly #23-458 the shoe pad thickness is 3/16 of an inch. Dexter says that you should replace the shoes if the material gets down to 1/16 of an inch thick or less.
view full answer...If the Kwikee 32 Series steps that you have were built in 2003 and you haven't done any work to them then the replacement motor that you are looking for is the part #LC379608. This is for 32 Series steps that were manufactured between 2000 -…
view full answer...Our customers have told us that the #LG-119226 Replacement Crank Handle works with most Atwood landing gear. I've linked to a product description video featuring the replacement handle. I've also provided a close-up photo showing what the end…
view full answer...The Ultra-Fab T-Slot Power Drill Adapter for Scissor Jacks #UF48-979071 will have a slot that is 1/4 inch wide and although not intended for your topwind trailer jack could maybe work. I've attached a picture that has several dimensions for you…
view full answer...Filter Your Search
Contact and Help