Replacement Crank Handle for Atwood 5th Wheel Landing Gear

Question

Question:

Hi I know our Atwood 75722 electric jack is no longer being manufactured. We need a replacement for our missing manual crank. Any suggestions?

asked by: Maureen V

0

Expert Reply:

Our customers have told us that the # LG-119226 Replacement Crank Handle works with most Atwood landing gear. I've linked to a product description video featuring the replacement handle.

I've also provided a close-up photo showing what the end of the crank looks like, so you can compare it to the manual drive on your landing gear.

expert reply by: Mike L

0

click to enlarge

Answer 1

Sure thing! The MaxxFan Roof Vent w/ 12V Fan #MA00A04301K is actually exhaust only. However, if you're wanting the exhaust & intake version, then you'll want the: -MaxxFan Plus Roof Vent w/ 12V Fan and Thermostat…

view full answer...

Answer 2

If the vent fan you have now is reversible then there should be a button on the assembly next to the other controls. However, if the fan is not reversible then all you need to do is reverse the wires on the motor (not the circuit board) and that…

view full answer...

Answer 3

The Ultra-Fab T-Slot Power Drill Adapter for Scissor Jacks #UF48-979071 will have a slot that is 1/4 inch wide and although not intended for your topwind trailer jack could maybe work. I've attached a picture that has several dimensions for…

view full answer...

Answer 4

It sounds like the switch in the jack is bad and should be replaced. Typically when an electric jack will go one direction but not the other its because the switch is broken. You might try checking all the fuses on the jack also. Since your trailer…

view full answer...

Answer 5

We do have the #UF48-979071 which is slightly larger than the Atwood part #AT85385. The Atwood has an opening of .53 inches whereas the Ultra Fab is .66 inch. See attached picture.

view full answer...

Answer 6

Thanks for the dimensions. I recommend replacing your current unit with the Jensen RV Stereo - Double DIN - AUX/USB, Bluetooth, jControl - 12V #JWM60A. The dimensions you gave don't directly fit any of our units, but the #JWM60A you asked…

view full answer...

Answer 7

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 8

The only real difference between the Alpha Systems #AL74UV and the LaSalle Bristol #3441700534142711440 is that the Alpha Systems is made of TPO which is a bit less flexible than Elvaloy-based PVC that #3441700534142711440 uses; PVC is going to be a…

view full answer...

Answer 9

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 10

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 11

To add a in-bed 7-way to your 2024 Chevy Silverado 2500 to make towing with a 5th wheel easier, I recommend adding the Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long item #C58FV. This harness puts a 4-way and 7-way…

view full answer...

Answer 12

Hi Christopher, There unfortunately isn't a guide to tell us the exact part numbers for the vents, skylights, etc. on your Passport. We offer a variety of plumbing vents and 12v fan vents but we unfortunately do not offer skylights. If you want…

view full answer...