Rim and Tire Recommendation to Replace a 20.5x8x10 Tire

Question

Question:

Rim 20.5x8x10

asked by: Kathya L

0

Expert Reply:

For the 20.5x8x10, the new size is a 205/65-10 like what is on the tire and rim combo # AM3H430 that you referenced. If you are looking for a wheel and tire combo in this size and yours has a 5 on 4-1/2 inch bolt pattern hub this would work well for you. If you are unsure what your wheel bolt pattern is check out the FAQ article I attached.

If all you need is a tire in that size you would want the part # AM1HP56. If you do need a rim and tire and instead have a 4 on 4 inch bolt pattern you would want the # AM3H370.

expert reply by: Jameson C

0

Answer 1

The modern equivalent to the 20.5x8.0-10 size tires on your pontoon trailer is the 205/65-10 size, which would fit your existing wheels without issue. The highest rated trailer tire we have available in this size is the Kenda Loadstar K399 Bias…

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 5

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 6

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 7

The 205/65-10 and the 20.5 x 8-10 would be very close in size. Assuming that 20.5 is the diameter of the tire and 8 is the width. The Kenda 205/65-10 Bias Trailer Tire with 10 inch White Wheel, #AM3H390, for example, is 8.3 inches wide with a…

view full answer...

Answer 8

The modern size equivalent of the 20.5x8-10 that you have currently would be the same size tire that is on the #AM3H340 that you referenced, 205/65-10. As long as the bolt pattern of your current hubs are 4 on 4 inch the wheels of this would bolt up…

view full answer...

Answer 9

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

I am sorry I don't have any tires that are going to fit your rim. I do have a couple of comparable size tires that come in a wheel tire combo. I have listed the two below along with their lug patterns. 5 on 4-1/2 Lug Pattern - Kenda 205/65-10…

view full answer...

Answer 12

Hi Phillip, The Furrion Arctic RV Refrigerator w/ Freezer #FR42PJ is going to come with a red, white, and green wire. The red wire is your positive, white is your negative, and green is your ground. Both the white and red can be ran to the DC…

view full answer...