How To Install The LaSalle Bristol Single Bowl RV Bathroom Sink # 34416305PWA

Question

Question:

How are the mounting tabs placed/attached to sink and countertop? No instructions or diagram with package

asked by: Chris

1

Helpful Expert Reply:

You'll need to place the LaSalle Bristol Single Bowl RV Bathroom Sink # 34416305PWA on the counter and then use the mounting tabs to clamp the sink to the underside of the counter. You'll screw a tab to each mounting point on the sink and face the tab outwards from the sink so it can grip the underside of the counter.

expert reply by: Kevin C

1

34416305PWA mounting points
(click to enlarge)

34416305PWA mounting tabs
(click to enlarge)

Answer 1

The LaSalle Bristol Single Bowl RV Bathroom Sink Item #34416270PWA does not include the drain tail pipe but, I have you covered. The LaSalle Bristol Pop Up Drain Item #34465WPR1303 is designed for this sink.

view full answer...

Answer 2

The mounting hardware that comes with the LaSalle Bristol Single Bowl RV Bathroom Sink #34416270PWA essentially acts as a clamping system. The screws will insert through the hole in the tabs and then into the threaded locations on the underside of…

view full answer...

Answer 3

When installing the LaSalle Bristol Single Bowl RV Bathroom Sink, #34416156PPA the drain tube to the sink (as well as seal the sink to your counter top) you will want to use a good silicone sealant, something such as TremPro 644 #0160297. This will…

view full answer...

Answer 4

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 5

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the…

view full answer...

Answer 6

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 7

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need…

view full answer...

Answer 8

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is…

view full answer...

Answer 11

I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I…

view full answer...

Answer 12

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

view full answer...

How To Install The LaSalle Bristol Single Bowl RV Bathroom Sink # 34416305PWA

Product Page this Question was Asked From

Continue Researching