Availability Of Suspension Hanger Bracket With Mounting Holes Near 3 On Center

Question

Question:

This part looks perfect I need the width of the bolt holes to be right at 3” Can you point me to the right part number? Thanks

asked by: Jay A

0

Expert Reply:

The CE Smith Front Hanger Bracket # CE14016G is the closest we have the Bracket # CE14026G. This hanger places the mounting holes at 3-3/8" on center.

expert reply by: Bud M

0

CE Smith Front Hanger Bracket # CE14016G Mounting Hole Dimensions
(click to enlarge)

Answer 1

The bolt hole spacing for the CE Smith Front/Rear Hanger Bracket for Double-Eye Springs #CE14026G is 4-3/8" x 1-5/8". I've attached a dimensional photo for you to check out as well as a review video to reference.

view full answer...

Answer 2

We only have 2 options for bolt-on hangers: - CE Smith Front/Rear Hanger Bracket for Double-Eye Springs #CE14026G which have an inside width of 1-1/4" - CE Smith Front/Center/Rear Hanger Bracket for Double-Eye Springs #CE14035G40 which have…

view full answer...

Answer 3

I've got a solution for you. Unfortunately the CE Smith Front/Rear Hanger Bracket for Double-Eye Springs - part #CE14026G you looked at aren't going to work. I measured the mounting hole on it and they are on 1 9/16" centers which means…

view full answer...

Answer 4

I can understand that if your boat is loaded on the trailer, you don't want to remove one of the wheels to measure the fenders. Measuring a fender with the tire still mounted can be tricky, but it's not impossible. I've provided a diagram…

view full answer...

Answer 5

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 6

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Since Grand Design is kind enough to list certain parts for their trailers I can confirm you have a 33" wheelbase on your 2020 Grand Design Transcend 27BHS. This means the MORryde Rubber Equalizers #MR87ZR will fit your trailer. Although I'm…

view full answer...

Answer 9

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 10

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 11

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 12

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...