Upgraded Equalizer and Replacement Leaf Springs for 2020 Grand Design Transcend 27BHS
Question:
Hello, I have a 2020 Grand design transcend 27BHS. I am looking at replacing the leaf springs with the Morryde equalizer and wet bolts. I believe I have the 33 wheel base but was wondering if there was a way to look this up with my model to be sure? Also I have 4 leaf leaf springs on a 4400lb axle. They are 26 from center bolt to center bolt. Can I put a 5 leaf or would that cause issues and could you confirm the correct spring I need? I drive it many miles and they have flattened out. Also do you think the Morryde or Road armor is the best for long distance driving as far as the wear time? On the Morryde instructions I measured the frame hanger spread and I get 59. I dont think the Road armor matters as it fits any of them from what I see. Thank you
asked by: Tim T
Helpful Expert Reply:
Since Grand Design is kind enough to list certain parts for their trailers I can confirm you have a 33" wheelbase on your 2020 Grand Design Transcend 27BHS. This means the MORryde Rubber Equalizers # MR87ZR will fit your trailer. Although I'm fairly certain the # MR46ZR is the right wet bolt kit, they do not list the shackle size so I recommend measuring. If you have 2-1/4" shackles then this is the correct kit. If you measure center hole to center hole and find it is 3-1/8" you need # MR76ZR instead.
I would choose the MORryde over the Road Armor # LC696740. You won't see a significant difference between the performance or longevity of the two. However, you do know the MORryde will be a good fit based on your wheelbase so that makes it an easy decision in my eyes.
Regarding the leaf springs, an additional leaf isn't going to cause any issues. Leaf count varies between leaf springs within the same capacity. The important thing is that you find the right capacity based on your axle. If your measurement was 26" from spring eye to spring eye with the leaf springs flattened out then you need something a little shorter. I recommend measuring the flat length to get the most accurate measurement. I have attached an article below which shows how to measure.
If you accounted for the leaf springs flattening then you could use the 6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles - 26" Long # e27SR. The capacity is slightly higher but that won't impact your ride quality. If you find that the 26" measurement is the flat length then the # e44SR would be more appropriate. This is 25-1/4" long eye to eye but would have a flat length of 26-1/2" which would work for you. Again, the higher capacity won't make a noticeable difference.
Products Referenced in This Question
6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles - 26" Long
- Trailer Leaf Springs
- Double Eye Springs
- 4500 lbs
- 1-3/4 Inch Wide
- 6 Leaf
- 26 Inch Long
- Painted
- etrailer
more information >
4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles - 25-1/4" Long
- Trailer Leaf Springs
- Double Eye Springs
- 5000 lbs
- 1-3/4 Inch Wide
- 4 Leaf
- 25-1/4 Inch Long
- Painted
- etrailer
more information >
Road Armor Shock Absorbing Equalizer Kit - Tandem Axle - Qty 2
- Trailer Leaf Spring Suspension
- Equalizer Upgrade Kit
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- 3500 lbs - 8000 lbs
- Double Eye Springs
- 6 Inch Long
- Tandem Axle
- Lippert
more information >
MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps
- Trailer Leaf Spring Suspension
- Suspension Kits
- Boat Trailer
- Snowmobile Trailer
- 3-1/8 Inch Long
- Tandem Axle
- MORryde
more information >
MORryde Rubber Equalizers for Tandem Axle Trailers - 33" Wheelbase - 8K
- Trailer Leaf Spring Suspension
- Equalizer Upgrade Kit
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 6-1/2 Inch Long
- Tandem Axle
- MORryde
more information >
Product Page this Question was Asked From
MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 2-1/4" Long Shackle Straps
- Trailer Leaf Spring Suspension
- Suspension Kits
- Boat Trailer
- Snowmobile Trailer
- 2-1/4 Inch Long
- Tandem Axle
- MORryde
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: MORryde Rubber Equalizers for Tandem Axle Trailers - 33" Wheelbase - 8K
- Video: MORryde Tandem Axle Trailer Rubber Equalizers Installation
- Q&A: How to Jack Up Trailer for Equalizer Replacement
- Search Results: tpms~trailer
- Search Results: morryde
- Search Results: break away cable
- Search Results: trailer hub bearing
- Search Results: u012~016
- Search Results: greasing tools
- Search Results: light
- Shop: 6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles - 26" Long
- Shop: 4-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-1/8" Long
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Shop: TireMinder TPMS for Dual Axle Trailers - Solar Powered - LCD Monitor - 4 Tire Sensors
- Shop: TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster - 4 Tire Sensors
- Q&A: Choosing Replacement Double-Eye Leaf Springs for StartCraft Pop-Up Trailer
- Shop: 2-1/2" Lubed Dust Cap and Rubber Plug - 2.45" x 1.52" x 1.18" - Qty 1
- Shop: Fastway Zip Coiled Trailer Breakaway Cable - 6' Long
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Shop: Blind Spot Detection
- Q&A: How To Measure To Make Sure The MORryde CRE3000 Equalizers Will Fit Your Trailer
- Q&A: Correct MORryde Shock Absorbing Equalizers and Wet Bolts for 2022 Grand Design Imagine XLS 22RBE
- Q&A: Can I Lift One Side of My Trailer at a Time to Install New Equalizers?
- Q&A: Does Changing From A 4 Leaf To A 6 Leaf Spring Add To Ride Height?
- Q&A: Can 3,500 lb Trailer Axle Springs be Replaced with 4,500 lb to Prevent Sagging
- Video: This Old Trailer: Replacing Leaf Springs