Recommended Roof Rack for a 2014 Hyundai Santa Fe Limited

Question

Question:

Dear, Please, I would like to know if this fits the Santa Fe Limited 2014 with sunroof. Thank you. Best regards

asked by: Ricardo

0

Expert Reply:

They will not but I have a set that does. If your 2014 Hyundai Santa Fe Limited has no rails on the roof you will need the Rhino-Rack ROC25 Roof Rack for Naked Roofs item # RR92SR.

If your Santa Fe does have the flush rails on the roof you will need the following parts:

Rhino-Rack Vortex Aero Crossbars - Aluminum - Black - 54" Long - Qty 2 item # RRVA137B-2

Rhino-Rack SX Series Legs for Vortex Aero Crossbars - Flush Factory Side Rails - Qty 4 item # RRSX032

expert reply by: Jerred H

0

Answer 1

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...

Answer 4

The best option to add a hitch to your 2014 Hyundai Santa Fe Sport is the etrailer item #e98841 you were looking at. This class III 2" hitch is custom fit and bolts to your Santa Fe with included hardware. It has more then enough capacity to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Alex, it sounds like you are looking for just the tracks of the Rhino Rack camper shell roof rack kit #Y02-480B which we do offer with the part #RTC16.

view full answer...

Answer 7

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 8

You do have the option to utilize the air brakes on your 2023 Freightliner Cascadia to control electric trailer brakes using the Hayes Air Actuated Trailer Brake Controller, part #HA100400C. However, we mostly recommend just using an electric brake…

view full answer...

Answer 9

Hey HPA, I would go with the Air Lift kit part #AL64VJ that fits your 2019 Toyota RAV4 based on what you described and your needs. This gives you adjustable support that you can tailor as needed so that you get the exact amount of support you need…

view full answer...

Answer 10

To install the Tekonsha Prodigy P3 Trailer Brake Controller #90195 in your Freightliner S2RV chassis the wiring is behind the kick panel in the drivers compartment. There is not a connector on the wires, they are simply terminated with tape. You will…

view full answer...

Answer 11

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 12

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...