Rhino-Rack Camper Shell Aero Bar Roof Rack Review Video

Thanks for reaching out, Joe! I recommend using the Rhino-Rack Aero Bar Roof Rack for Camper Shells #Y02-480B which comes with 63" long tracks as well as 54" long crossbars which should give you a little bit of overhang on your canopy. Per…

Hey Alex, it sounds like you are looking for just the tracks of the Rhino Rack camper shell roof rack kit #Y02-480B which we do offer with the part #RTC16.

The Rhino-Rack Aero Bar Roof Rack for Camper Shells part #Y02-480B is a great option for fiberglass truck bed campers as it was made for this exact purpose. It can support up to 220 lbs but bear in mind this rating is tested independently of the…

We do! I recommend using the Rhino-Rack Aero Bar Roof Rack for Camper Shells #Y02-480B on your 2024 Chevy Silverado 1500 topper. To get this installed you'll have to put some holes in the topper for the rails, but it comes with sealant and…

Hey there Stormy, I think we can figure this out, as there are a quite a few options. First, let's just discount the heavy-duty rack, as those are just oddly shaped crossbars and there's nothing HD about them (like you mentioned, they have…

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

Thank you for the photo; and while it is very likely, I don't have the exact dimensions of the Leer Hi/Lo camper shell on your 2004 Chevy Silverado with an 8 foot bed in order to say with certainty if you can use the Rhino-Rack roof rack you…

To convert the factory 4-Way flat trailer connector on the back of your 2010 Ford F-150, you will need Adapter 4 Pole to 7 Pole and 4 Pole, #37185. You will plug the factory 4-Way into the back of the adapter and hardwire the remaining 4 wires. The…

Yes, the 63" Rhino-Rack RTC-Style Roof Rack Tracks - Channel Mount part #RTC16 can be cut down to the size you need as long as you cut them perfectly straight to allow the end caps to go back on because at this time we do not carry them as a…

There were versions of the A.R.E. camper shells that had tracks on them already. The factory rails were made by Yakima. For a complete roof rack system on your A.R.E. topper you will need the following parts if you have the rails: 4 of the Yakima…

The Adapter 4-Pole to 7-Pole and 4-Pole #37185 is a universal part that will work on most vehicles and will require you to either run additional wiring for the charge line circuit, brake line and reverse light wires. These can either be new wiring…

I can't see why you wouldn't be able to cut the Yakima 54" Tracks for Roof Racks #Y26RR if need be. As long as you're able to cut it cleanly to where the end cap would fit back in place as it was before, you'll be good to go. We…