Safe Working Load Limit of Erickson ATV E-Track Tie-Down Kit 4 Wheel Set

Question

Question:

IS THIS 1500 LBS PER STRAP OR ALL 4 TOGETHER

asked by: Brett D

0

Expert Reply:

The 1,500 lb safe working load limit of the # EM98CV is per pair of straps. This is the same as two of the # EM09160. Since this has two pair, the WLL would become 3,000 lbs. As long as you are not exceeding 3,000 lbs these are a great choice for your application. I also highly recommend the etrailer E-Track Backing Plates w/ Hardware # e66RR to keep them secure.

expert reply by: Robin H

0

Answer 1

Yes, we do offer the straps from the Erickson ATV E-Track Tie-Down Kit separately. I have listed these for you below, they vary by length. 12' - part #EM59136 16' - part #EM59139 20' - part #EM59140

view full answer...

Answer 2

Yes the etrailer E-track backing plate part #e66RR does work with other brand e-track like the US Cargo E-track you mentioned.

view full answer...

Answer 3

You can install the etrailer Horizontal E-Track #e62VR and drive over it just fine with a vehicle as the tracks only sit 1/2" tall - then you can secure your side by sides with a tie-down kit like part #EM98CV you were looking at. To secure the…

view full answer...

Answer 4

Yes, the Erickson ATV E-Track Tie-Downs #EM98CV includes wheels chocks and straps for four wheels and will accommodate vehicles weighing in at 3000lb maximum with tires between 10" and 30" in diameter. Since your 2006 Kawasaki Mule 3010…

view full answer...

Answer 5

We don't have any E-track ratchet straps that are as short as you are wanting but I have a different solution that I think you would like with the Erickson ATV E-Track Tie-Down Kit w/ Ratchet Straps and Wheel Chocks #EM98CV. You'd mount these…

view full answer...

Answer 6

There may be a solution for you though the Traffic Cone Holder for E-Track or Rack'em Spare Tire Holder #RA-26 does not have a specific weight rating for one of the brackets. There are a couple options for you to consider like the CargoSmart…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 11

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 12

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...